Incoloy alloy MA956. Strain rate and temperature effects on the microstructure and ductility
نویسنده
چکیده
منابع مشابه
Factors Affecting Weldability Improvement of Dissimilar Welds of Aged HP Stainless Steel and Alloy 800
The microstructure of HP stainless steel in aged and aged + solution annealed conditions and solutionized alloy 800 was characterized by optical microscopy, scanning electron microscopy (SEM), and transmission electron microscopy (TEM) equipped by EDS. All phases present in the above condition were described. The effects of solution annealing heat treatment temperature on the microstructure, te...
متن کاملMechanical Behavior of an Ultrafine/Nano Grained Magnesium Alloy
The application of magnesium alloys is greatly limited because of their relatively low strength and ductility. An effective way to improve the mechanical properties of magnesium alloy is to refine the grains. As the race for better materials performance is never ending, attempts to develop viable techniques for microstructure refinement continue. Further refining of grain size requires, however...
متن کاملStudy on the Microstructure of Hot Deformed Cu-28Zn Prealloyed Powder Compacts
The role of microstructure on hot deformation behavior of sintered Cu-28Zn prealloyed powder compacts was investigated by a series of isothermal hot compression tests in the temperature range of 550- 850°C at strain rates of 0.001, 0.01, 0.1 and 0.5 s-1, by taking into consideration the Hyperbolic Sine functional behavior to analyze the deformation behavior of the alloy. The results indicate th...
متن کاملEnhancement of mechanical properties of low carbon steel based on heat treatment and thermo-mechanical processing routes
Thermal treatments and thermo-mechanical processing routes were applied on a conventional structural steel (st37 steel: 0.12C-1.11Mn-0.16Si) for improvement of tensile properties and enhancement of work-hardening behavior. Full annealing resulted in a sheet with coarse ferrite grains and pearlite colonies arranged alternatively in distinct bands, which showed high ductility, low strength, and t...
متن کاملThe effect of temperature and strain rate on elongation to failure in nanostructured Al-0.2wt% Zr alloy fabricated by ARB process
A nano/ultra-fine grain Al-0.2wt% Zr alloy was produced by accumulated roll bonding (ARB) processafter 10 cycles. The fraction of high angle grain boundaries increased from 8% to 65.4% during 10passes during ARB process. This alloy was subjected to tensile test at different temperatures (523,573and 623 K) and strain rates (0.1 and 0.01 s-1). The optimum condition of temperature and strain rate ...
متن کامل