Silicide-phase evolution and platinum redistribution during silicidation of Ni0.95Pt0.05/Si(100) specimens
نویسندگان
چکیده
We investigated the temporal evolution of nickel-silicide phase-formation and the simultaneous redistribution of platinum during silicidation of a 10 nm thick Ni0.95Pt0.05 film on a Si(100) substrate. Grazing incidence x-ray diffraction (GIXRD) and atom-probe tomography (APT) measurements were performed on as-deposited films and after rapid thermal annealing (RTA) at 320 or 420 C for different times. Observation of the Ni2Si phase in as-deposited films, both with and without platinum alloying, is attributed to surface preparation. RTA at 320 C for 5 s results in the formation of the low-resistivity NiSi intermetallic phase and nickel-rich phases, Ni2Si and Ni3Si2, as demonstrated by GIXRD measurements. At 420 C for 5 s, the NiSi phase grows outward from the silicide/Si(100) interface by consuming the nickel-rich silicide phases. On increasing the annealing time at 420 C to 30 min, this reaction is driven towards completion. The nickel-silicide/silicon interface is reconstructed in three-dimensions employing APT and its chemical root-mean-square roughness, based on a silicon isoconcentration surface, decreases to 0.6 nm with the formation of the NiSi phase during silicidation. Pt redistribution is affected by the simultaneous reaction between Ni and Si during silicidation, and it influences the resulting microstructure and thermal stability of the NiSi phase. Short-circuit diffusion of Pt via grain boundaries in NiSi is observed, which affects the resultant grain size, morphology, and possibly the preferred orientation of the NiSi grains. Pt segregates at the NiSi/Si(100) heterophase interface and may be responsible for the morphological stabilization of NiSi against agglomeration to temperatures greater than 650 C. The Gibbsian interfacial excess of Pt at the NiSi/Si(100) interface after RTA at 420 C for 5 s is 1.26 0.01 atoms nm 2 and then increases to 2.16 0.02 atoms nm 2 after 30 min at 420 C, corresponding to a decrease in the interfacial free energy of 7.1 mJ m . VC 2012 American Institute of Physics. [http://dx.doi.org/10.1063/1.4751023]
منابع مشابه
Nickel Silicide Formation using Pulsed Laser Annealing for nMOSFET Performance Improvement
The formation of a uniform, high tensile stress and low silicide/Si interfacial resistance nickel silicide in nMOSFET by introducing pulsed laser annealing (PLA) is reported. This annealing approach facilitated the phase transformation of nickel silicide to Si-rich NiSix compounds using a low-thermal-budget process, improves the silicide/Si interface regularity and avoids familiar (111) NiSi2 f...
متن کاملSchottky and ohmic contacts to doped Si1ÿxÿyGexCy layers
We report on titanium contacts to n-type and p-type Si1ÿxÿyGexCy strained heteroepitaxial layers on (100)Si and material and electrical characterization of n-type and p-type platinum±silicide±germanide contacts to Si1ÿxÿyGexCy strained heteroepitaxial layers on (100)Si. Ti contacts to n-type Si1ÿxÿyGexCy show rectifying behavior at low doping levels but become ohmic as layers reach 10 cmÿ3. Ti ...
متن کاملImproved Thermal Stability of NiSi Nanolayer in Ni-Si Co-sputtered Structure
Electrical, structural and morphological properties of Ni silicide films formed in Ni(Pt 4at.% )/Si(100) and Ni0.6Si0.4(Pt4at.% )/Si(100) structures at various annealing temperatures ranging from 200 to 1000 oC were studied. The Ni(Pt) and Ni0.6Si0.4(Pt) films with thickness of 15 and 25 nm were deposited by RF magnetron co-sputtering method, respectively. The annealing process of the structur...
متن کاملChallenges of nickel silicidation in CMOS technologies ¬リニ
In this paper, we review some of the key challenges associated with the Ni silicidation process in the most recent CMOS technologies. The introduction of new materials (e.g. SiGe), and of non-planar architectures bring some important changes that require fundamental investigation from a material engineering perspective. Following a discussion of the device architecture and silicide evolution th...
متن کاملInvestigation of composite powder synthesis (Al2O3-WXSiY-WXBY) in aluminothermic combustion system (Al+B2O3+Si+WO3) using thermal analysis
Composites that are including silicide of tungsten and boride of tungsten intermetallic compound have properties such as high hardness, relatively good thermal shock, chemical stability and high strength at high temperature. The purpose of this investigation is evaluation of phase and microstructure of alumina base composite reinforced by boride and silicide of tungsten in three systems 1-Al+...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2012