On the feasibility of tilt test outcome early prediction using ECG and pressure parameters

نویسندگان

  • Francisco Javier Gimeno-Blanes
  • José Luis Rojo-Álvarez
  • Antonio J. Caamaño
  • J. A. Flores-Yepes
  • Arcadio García-Alberola
چکیده

The tilt test is a valuable clinical tool for vasovagal syncope (VVS) diagnostic, and its early prediction from simple ECG and blood pressure-based parameters has widely been studied in the literature. However, no practical system is currently used in the clinical setting for the early prediction of the tilt test outcome. The objectives of this study were (1) to benchmark the early prediction performance of all the previously proposed parameters, when nonlinearly combined; (2) to try to improve this performance with the inclusion of additional information and processing techniques. We analyzed a database of 727 consecutive cases of tilt test. Previously proposed features were measured from heart rate and systolic/diastolic pressure tachograms, in several representative signal segments. We aimed to improve the prediction performance: first, using new nonlinear features (detrended fluctuation analysis and sample entropy); second, using a multivariable nonlinear classifier (support vector machine); and finally, including additional physiological signals (stroke volume). The predictive performance of the nonlinearly combined previously proposed features was limited [area under receiver operating characteristic curve (ROC) 0.57 ± 0.12], especially at the beginning of the test, which is the most clinically relevant period. The improvement with additional available physiological information was limited too. We conclude that the use of a system for tilt test outcome prediction with current knowledge and processing should be considered with caution, and that further effort has to be devoted to understand the mechanisms of VVS.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Flow Pattern and Oil Holdup Prediction in Vertical Oil–Water Two–Phase Flow Using Pressure Fluctuation Signal

In this work, the feasibility of flow pattern and oil hold up the prediction for vertical upward oil–water two–phase flow using pressure fluctuation signals was experimentally investigated. Water and diesel fuel were selected as immiscible liquids. Oil hold up was measured by Quick Closing Valve (QCV) technique, and five flow patterns were identified using high-speed photo...

متن کامل

Optimization of friction stir welding parameters for toughness in super duplex stainless steel

In this paper, using the Taguchi method, the parameters affecting the toughness of super duplex stainless steels in friction stir welding were optimized. In order to achieve optimal conditions, maximum toughness, the quality characteristic was used as the higher the better. Analysis of Taguchi results showed that in order to achieve optimal conditions in super duplex stainless steel weldments m...

متن کامل

Optimization of friction stir welding parameters for toughness in super duplex stainless steel

In this paper, using the Taguchi method, the parameters affecting the toughness of super duplex stainless steels in friction stir welding were optimized. In order to achieve optimal conditions, maximum toughness, the quality characteristic was used as the higher the better. Analysis of Taguchi results showed that in order to achieve optimal conditions in super duplex stainless steel weldments m...

متن کامل

Effect of Early Mobilization on Hemodynamic Parameters of Patients Undergoing Sleeve Gastrectomy; A Randomized Clinical Trial

Aims: Today, due to the failure of non-surgical methods in the treatment of obesity, surgical procedures such as sleeve gastrocetomy are used. Similar to other invasive interventions, sleeve gastrectomy causes an imbalance in hemodynamic parameters. The aim of this study was to determine the effect of early mobilization on hemodynamic parameters in patients undergoing sleeve gastrectomy. Mater...

متن کامل

Performance evaluation of chain saw machines for dimensional stones using feasibility of neural network models

Prediction of the production rate of the cutting dimensional stone process is crucial, especially when chain saw machines are used. The cutting dimensional rock process is generally a complex issue with numerous effective factors including variable and unreliable conditions of the rocks and cutting machines. The Group Method of Data Handling (GMDH) type of neural network and Radial Basis Functi...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • EURASIP J. Adv. Sig. Proc.

دوره 2011  شماره 

صفحات  -

تاریخ انتشار 2011