Dopant-free GaN/AlN/AlGaN radial nanowire heterostructures as high electron mobility transistors.
نویسندگان
چکیده
We report the rational synthesis of dopant-free GaN/AlN/AlGaN radial nanowire heterostructures and their implementation as high electron mobility transistors (HEMTs). The radial nanowire heterostructures were prepared by sequential shell growth immediately following nanowire elongation using metal-organic chemical vapor deposition (MOCVD). Transmission electron microscopy (TEM) studies reveal that the GaN/AlN/AlGaN radial nanowire heterostructures are dislocation-free single crystals. In addition, the thicknesses and compositions of the individual AlN and AlGaN shells were unambiguously identified using cross-sectional high-angle annular darkfield scanning transmission electron microscopy (HAADF-STEM). Transport measurements carried out on GaN/AlN/AlGaN and GaN nanowires prepared using similar conditions demonstrate the existence of electron gas in the undoped GaN/AlN/AlGaN nanowire heterostructures and also yield an intrinsic electron mobility of 3100 cm(2)/Vs and 21,000 cm(2)/Vs at room temperature and 5 K, respectively, for the heterostructure. Field-effect transistors fabricated with ZrO(2) dielectrics and metal top gates showed excellent gate coupling with near ideal subthreshold slopes of 68 mV/dec, an on/off current ratio of 10(7), and scaled on-current and transconductance values of 500 mA/mm and 420 mS/mm. The ability to control synthetically the electronic properties of nanowires using band structure design in III-nitride radial nanowire heterostructures opens up new opportunities for nanoelectronics and provides a new platform to study the physics of low-dimensional electron gases.
منابع مشابه
Dependence of Electrical Properties of InAlN/GaN and InAlN/AlGaN/GaN Heterostructures FETs on the AlN Interlayer Thickness
We investigated the influence of the thickness of the AlN interlayer for InAlN/GaN and InAlN/AlGaN/GaN heterostructures. The AlN thickness strongly affects the surface morphology and electron mobility of the InAlN/GaN structures. The rms roughness of the surface increases from 0.35 to 1.2 nm with increasing AlN thickness from 0 to 1.5 nm. Large pits are generated when the AlN is thicker than 1 ...
متن کاملEffects of hydrostatic pressure and temperature on the AlGaN/GaN High electron mobility transistors
In this paper, drain-source current, transconductance and cutoff frequency in AlGaN/GaN high electron mobility transistors have been investigated. In order to obtain parameters of exact AlGaN/GaN high electron mobility transistors such as electron density, the wave function, band gap, polarization charge, effective mass and dielectric constant, the hydrostatic pressure and temperature effects a...
متن کاملOn the Operation Mechanism and Device Modeling of AlGaN/GaN High Electron Mobility Transistors (HEMTs)
In this work, the physical based device model of AlGaN/GaN high electron mobility transistors (HEMTs) has been established and the corresponding device operation behavior has been investigated also by using Sentaurus TCAD from Synopsys. Advanced AlGaN/GaN hetero-structures with GaN cap layer and AlN spacer have been considered and the GaN cap layer and AlN spacer are found taking important role...
متن کاملHighly Conductive Modulation-Doped Graded p-AlGaN/(AlN)/GaN Multi-Heterostructures
In this study we present theoretical and experimental results regarding modulation doped p-AlGaN/(AlN)/GaN multi-heterostructures. As the heterostructures should yield both, higher lateral and better vertical conductivity than p-doped GaN, band structure simulations have been performed prior to growth experiments. Based on the simulation results several samples were grown by metalorganic vapor ...
متن کاملMigration Enhanced Metalorganic Chemical Vapor Deposition of AlN/GaN/InN based heterostructures
We applied a new Migration Enhanced Metalorganic Chemical Vapor Deposition (MEMOCVD) epitaxial technique for growing AlN/GaN/InN epitaxial films and heterostructure layers on 2”, 3” and 4” substrates. The growth of the AlN/GaN/InN layers was carried out using controlled precursor pulsed flows to achieve accurate thickness control over large area substrates. This technique bridges the gap betwee...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
- Nano letters
دوره 6 7 شماره
صفحات -
تاریخ انتشار 2006