SAR interferometry at Venus for topography and change detection

Since the Magellan radar mapping of Venus in the early 1990’s, techniques of synthetic aperture radar interferometry (InSAR) have become the standard approach to mapping topography and topographic change on Earth. Here we investigate a hypothetical radar mission to Venus that exploits these new methods. We focus on a single spacecraft repeat-pass InSAR mission and investigate the radar and mission parameters that would provide both high spatial resolution topography as well as the ability to detect subtle variations in the surface. Our preferred scenario is a longer-wavelength radar (S or L-band) placed in a near-circular orbit at 600 km altitude. Using longer wavelengths minimizes the required radar bandwidth and thus the amount of data that will be transmitted back to earth; it relaxes orbital control and knowledge requirements. During the first mapping cycle a global topography map would be assembled from interferograms taken from adjacent orbits. This approach is viable due to the slow rotation rate of Venus, causing the interferometric baseline between adjacent orbits to vary from only 11 km at the equator to zero at the inclination latitude. To overcome baseline decorrelation at lower latitudes, the center frequency of a repeated pass will be adjusted relative to the center frequency of its reference pass. During subsequent mapping cycles, small baseline SAR acquisitions will be used to search for surface decorrelation due to lava flows. While InSAR methods are used routinely on Earth, their application to Venus could be complicated by phase distortions caused by the thick Venus