Track loading limits and cross acceptance of vehicle approvals

The requirements for track loading limits are one of the main barriers to simple crossacceptance of vehicles where rolling stock that is already operating successfully in one (or more) networks has to be re-tested before it can be approved for operation on another network. DynoTRAIN WP 4 studied this area in order to determine whether the additional requirements were justified, or if the process could be made much cheaper and simpler without increasing the risk of track deterioration for the networks. The review of national requirements identified modified criteria and limit values for track forces in some member states but these can be obtained from additional analysis of the normal test results with no new tests required. The influence of design rail inclination has also been found not to be significant, provided a realistic range of wheel-rail contact conditions are included in the tests. For line speeds greater than or equal to 160km/h the current standards for track construction across the member states appear to be similar. On lower speed lines in some countries, a ‘weaker’ track condition may require a lower limit on one of the vehicle assessment parameters. Track dynamics modelling has shown that the vehicle assessment parameters used in international standards are suitable for use in cross-acceptance for track forces. The use of multiple regression analysis allows the estimated maximum value for relevant parameters to be evaluated for different target conditions and then compared with the appropriate limit value, or with values for existing, comparable vehicles. Guidance has also been provided on the relevant parameters to consider when developing operating controls for different types of track deterioration.