A Study of the Abrasion of Squeegees Used in Screen Printing and Its Effect on Performance with Application in Printed Electronics

This article presents a novel method for accelerated wear of squeegees used in screen printing and describes the development of mechanical tests which allow more in-depth measurement of squeegee properties. In this study, squeegees were abraded on the screen press so that they could be used for subsequent print tests to evaluate the effect of wear on the printed product. Squeegee wear was found to vary between different squeegee types and caused increases in ink transfer and wider printed features. In production this will lead to greater ink consumption, cost per unit and a likelihood of product failure. This also has consequences for the production of functional layers, etc., used in the construction of printed electronics. While more wear generally gave greater increases in ink deposition, the effect of wear differed, depending on the squeegee. There was a correlation between the angle of the squeegee wear and ink film thickness from a worn squeegee. An ability to resist flexing gave a high wear angle and presented a sharper edge at the squeegee/screen interface thus mitigating the effect of wear. There was also a good correlation between resistance to flexing and ink film thickness for unworn squeegees, which was more effective than a comparison based on Shore A hardness. Squeegee indentation at different force levels gave more information than a standard Shore A hardness test and the apparatus used was able to reliably measure reductions in surface hardness due to solvent absorption. Increases in ink deposition gave lower resistance in printed silver lines; however, the correlation between the amount of ink deposited and the resistance, remained the same for all levels of wear, OPEN ACCESS Coatings 2014, 4 357 suggesting that the wear regime designed for this study did not induce detrimental print defects such as line breakages.