Interference and Topology Control
نویسنده
چکیده
The concept of ad-hoc networks has first arisen in 1970s. Adhoc networks act differently than other wireless networks, for each node can act as a router. For that ad-hoc networks can be used in some interesting applications. However, if the network wasn’t well constructed, it would have an inefficient performance. Interference can be considered to be one of the worst problems, the network can suffer from, as the interference causes energy consuming besides time delay. This paper consists of five sections namely: Introduction, Goals which the original paper would like to achieve in Desired Graph, problems and challenges might be faced in order to establish the desired graph in Related Issues. The fourth section will introduce the three suggested algorithms LIFE,LISE,LLISE, and how they claim to hold all the requirments; finally a conclusion and evaluation to the overall paper.
منابع مشابه
Three-Phase to Single-Phase Matrix Converters: New Topology Based on New Control Method
In this paper, a new topology is proposed for three-phase to single-phase matrix converters, where more voltage levels are produced in the output in comparison with the conventional topologies. In addition, a new control method based on minimum error between the generated and the desired output voltages is proposed for three-phase to single-phase matrix converters. In the proposed control metho...
متن کاملTopology Control for Energy Conservation in Wireless Sensor Network
Topology control in Wireless Sensor Networks is an approach to reduce the initial topology of the network in such a way that energy of the sensor nodes may be conserved and the interference among simultaneous transmissions may be reduced. We have described the topology control for heterogeneous WSNs and defined different interference model in heterogeneous WSNs and the techniques to minimize th...
متن کاملOverview of Topology Control in Wireless Sensor Networks
Topology control is one of the most importance issues in performance optimization for wireless sensor network. It can prolong network lifetime, reducing radio interference, ensuring network connectivity and coverage. In this survey paper, we discuss the design object of topology control, study the different network topology models and graph models which used in topology control, typical topolog...
متن کاملLow-Interference Topology Control for Wireless Ad Hoc Networks
Topology control has been well studied in wireless ad hoc networks. However, only a few topology control methods take into account the low interference as a goal of the methods. Some researchers tried to reduce the interference by lowering node energy consumption (i.e. by reducing the transmission power) or by devising low degree topology controls, but none of those protocols can guarantee low ...
متن کاملFICTC: fault-tolerance-and-interference-aware topology control for wireless multi-hop networks
K-connectivity-based topology control can improve fault-tolerant performance of multi-hop wireless networks. Existing algorithms mainly focused on preserving the same k-connectivity between any two nodes. However, in practical network deployments, the algorithms enforcing k-connectivity degrade network performance, when the topology requires heterogeneous nodal fault-tolerant requirements. In t...
متن کاملInterference Reduction in Wireless Networks
The presence of interference in wireless networks is quickly being focused upon as a problem in today’s world. Unfortunately, research is so young that leading researchers have differing ideas regarding the identification of a universal measure of network interference. But some goals have become cemented as necessary, such as the requirement of a low interference network that does not sacrifice...
متن کامل