Development of a micro cell compression stimulator for evaluating real-time cellular responses.

This paper presents a micro cell compression stimulator for evaluating real-time cellular responses to compression stimuli. The device was produced by a micro three-dimensional structure fabrication process using multiple exposures to the photoresist. The device consists of a pressure inlet port, cell inlet ports, a gasket, microchannels, cell culture chambers, and a diaphragm on the culture chamber for applying compressive pressure to cells. Compression stimuli applied to the cells can be controlled by regulating the expansion of the diaphragm via a pressure control. The device permits the observation of cellular responses to compressive pressure in real time because it is made of transparent materials and stimulates the cells without deforming the cell culture surface, when observed by optical microscopy. We demonstrated the validity of the fabrication process, evaluated the performance of the fabricated device, and compared the experimental results with the FEM structural analysis results. We found through operational testing that the diaphragm was deformed quickly by applying negative/positive pressure and that the diaphragm displacement became larger with increasing applied pressure. These results indicate that this device can be used to control the intensity and the cell stimulus profile by regulating the applied pressure. In all cases, the cellular deformation during compression stimulus was successfully observed in real time using an optical microscope. The device is expected to facilitate the control of stem cell differentiation and the clarification of cellular mechanoreceptor mechanisms and signal transduction pathways.