Four-dimensional CDT with toroidal topology

نویسندگان

  • J. Ambjørn
  • A. Görlich
  • K. Grosvenor
  • J. Jurkiewicz
چکیده

3 + 1 dimensional Causal Dynamical Triangulations (CDT) describe a quantum theory of fluctuating geometries without the introduction of a background geometry. If the topology of space is constrained to be that of a three-dimensional torus we show that the system will fluctuate around a dynamically formed background geometry which can be understood from a simple minisuperspace action which contains both a classical part and a quantum part. We determine this action by integrating out degrees of freedom in the full model, as well as by transfer matrix methods. © 2017 The Author(s). Published by Elsevier B.V. This is an open access article under the CC BY license (http://creativecommons.org/licenses/by/4.0/). Funded by SCOAP3.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

1 Constraints on the topology of higher dimensional black holes

As discussed in the first chapter, black holes in four dimensions satisfy remarkable uniqueness properties. Of fundamental importance is the classical result of Carter, Hawking and Robinson that the Kerr solution, which is characterized by its mass M and angular momentum J , is the unique four dimensional asymptotically flat stationary (i.e., steady state) solution to the vacuum Einstein equati...

متن کامل

Multi-toroidal Interconnects: Using Additional Communication Links to Improve Utilization of Parallel Computers

Three-dimensional torus is a common topology of network interconnects of multicomputers due to its simplicity and high scalability. A parallel job submitted to a three-dimensional toroidal machine typically requires an isolated, contiguous, rectangular partition connected as a mesh or a torus. Such partitioning leads to fragmentation and thus reduces resource utilization of the machines. In par...

متن کامل

DAMAGE IDENTIFICATION BY USING MODAL EXPANSION AND TOPOLOGY OPTIMIZATION IN THREE DIMENSIONAL ELASTICITY PROBLEMS

In this paper, topology optimization is utilized for damage detection in three dimensional elasticity problems. In addition, two mode expansion techniques are used to derive unknown modal data from measured data identified by installed sensors. Damages in the model are assumed as reduction of mass and stiffness in the discretized finite elements. The Solid Isotropic Material with Penalization (...

متن کامل

Note on "Average resistance of toroidal graphs" by Rossi, Frasca and Fagnani

In our recent paper W.S. Rossi, P. Frasca and F. Fagnani, “Average resistance of toroidal graphs”, SIAM Journal on Control and Optimization, 53(4):2541–2557, 2015, we studied how the average resistances of d-dimensional toroidal grids depend on the graph topology and on the dimension of the graph. Our results were based on the connection between resistance and Laplacian eigenvalues. In this not...

متن کامل

Topological dilaton black holes

In the four-dimensional spacetime, when the two-sphere of black hole event horizons is replaced by a two-dimensional hypersurface with zero or negative constant curvature, the black hole is referred as to a topological black hole. In this paper we present some exact topological black hole solutions in the Einstein-Maxwell-dilaton theory with a Liouville-type dilaton potential. PACS numbers: 04....

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2018