Exploring the relaxation time, bond length and length of the polymer chain in the kinetics of end-to-end looping of a long polymer chain
نویسندگان
چکیده
We present a theoretical model for understanding the kinetics of a long polymer in solution. A Smoluchowski-like equation has been used to model the problem of polymer looping with a Dirac delta function sink of finite strength. The results for rate constants have been obtained by using Green’s function. In this model, the rate constants for end-to-end looping of polymer exhibits simple Arrhenius behavior. The rate constants are sensitive to relaxation time, bond length and chain length dependence of the looping probability. In particular, for short term rate constant, relaxation time makes loop formation between two ends of a polymer chain slower but has a direct dependence with long term rate constant. We also show that for shorter polymer strands looping is slower as compared to polymer having longer chain length. The long term rate constant shows inverse square root dependence on the length of the chain. The bond length strongly affects the probability of loop formation as for long constructs of polymer, the end-to-end distance is found to exhibit inverse power law relationship to bond length. We also observe that the short term rate constant for flexible polymer shows stronger affinity for loop formation. ∗Corresponding author Email address: [email protected] (Moumita Ganguly) Phone:-+91-190-5267067, Fax: +91-1905-237945 Preprint submitted to Chemical Physics Letters April 25, 2017
منابع مشابه
The influence of branching efficiency on the rheology and morphology of melt state long chain branched polypropylene/polybutene-1 blends
In this study, the compatibility of the blends of polypropylene (PP) and polybutene-1(PB-1) homopolymer before and after long chain branching process were studied. The blends were prepared and long-chain branched directly via reactive extrusion process in presence of free radical initiator and trimethylolpropane tri methacrylate (TMPTMA) poly functional monomer. The optimum percentage of TMPTMA...
متن کاملرسانندگی الکترونی سیمهای مولکولی پلیپیرول (PPy) و ظهور پدیده فانو رزونانس
In this paper, we studied the electronic conductance of a polypyrrole polymer, which is embedded between two semi-infinite simple chains by using Green’s function technique in tight-binding approach. We first reduced the center polymer to a one dimensional chain with renormalized onsite and hopping energies by renormalization method. Then, we calculated the system conductivity as a function of ...
متن کاملRate-Dependent Adhesion between Opposed Perfluoropoly(alkyl ether) Layers: Dependence on Chain-End Functionality and Chain Length
Adhesion was measured repeatedly between opposed molecularly thin layers of perfluoropoly(alkyl ether)s on mica, with particular attention to the dependence of the adhesion on chain-end functionality and chain length of the polymer. The polymer layers were kept in contact for specified times that differed by 4 orders of magnitude (0.01-500 s) and then unloaded (separated) at rates that varied b...
متن کاملDiffusion-limited loop formation of semiflexible polymers: Kramers theory and the intertwined time scales of chain relaxation and closing
– We show that Kramers rate theory gives a straightforward, accurate estimate of the closing time τc of a semiflexible polymer that is valid in cases of physical interest. The calculation also reveals how the time scales of chain relaxation and closing are intertwined, illuminating an apparent conflict between two ways of calculating τc in the flexible limit. The looping of polymers is a physic...
متن کاملEFFECT OF END GROUPS AND CHAIN LENGTH ON EXTRACTION OF LITHIUM ION BY A SERIES OF NON-CYCLIC IONOPHORES
A series of non-cyclic polyethers with different end groups and chain length were used for the extraction of lithium salt from aqueous into various organic phases viz. Chloroform, Carbon tetrachloride, 1,2-dichloroethane, to study the influence of structural variations within the extractant molecule upon the extraction selectivity and efficiency. The ionophores used were viz. DEG (I), DEGDME (I...
متن کامل