Fast Scanning and Quick Sampling in Computed Tomography
نویسنده
چکیده
Essentially, 3D computed tomography (CT) image should be obtained from huge data (raysum) set from multiple views and multiple projections. Due to mechanical limitation, a compromise between fast scanning process and quick data sampling has to be considered. This paper presents our approach on performing the fast scanning process and quick data sampling in order to obtained good CT image with acceptable criteria. A set of nice results were presented.
منابع مشابه
Dose Reduction Methods in Chest Computed Tomography
Introduction: Computed tomography is one of the most powerful tools for investigating thorax disease, because it shows progression of lung disease much clearer than chest radiography. Technical advances in CT scanners have led to some abilities for CT scanners such as coverage of larger volume, lower noise and ability for acquiring image in one respiratory phase. However, this will be accompani...
متن کاملArtifact reduction techniques in Cone Beam Computed Tomography (CBCT) imaging modality
Introduction: Cone beam computed tomography (CBCT) was introduced and became more common based on its low cost, fast image procedure rate and low radiation dose compared to CT. This imaging modality improved diagnostic and treatment-planning procedures by providing three-dimensional information with greatly reduced level of radiation dose compared to 2D dental imaging modalitie...
متن کاملFeasibility study on many-view under- sampling technique for low-dose computed tomography
We proposed a novel scanning method for low-dose computed tomography (CT) that uses an oscillating multi-slit collimator between the x-ray source and the patient. It can be thought as a realization of sparse data sampling that does not require a fast x-ray power switching. A simulation study was performed based on experimentally acquired microCT data of a mouse to demonstrate the feasibility of...
متن کاملFast System Matrix Calculation in CT Iterative Reconstruction
Introduction: Iterative reconstruction techniques provide better image quality and have the potential for reconstructions with lower imaging dose than classical methods in computed tomography (CT). However, the computational speed is major concern for these iterative techniques. The system matrix calculation during the forward- and back projection is one of the most time- cons...
متن کاملEvaluation of Effect of Different Computed Tomography Scanning Protocols on Hounsfield Unit and Its Impact on Dose Calculation by Treatment Planning System
Introduction: In radiotherapy treatment planning system (TPS), basic input is the data from computed tomography (CT) scan, which takes into account the effect of inhomogeneities in dose calculations. Measurement of CT numbers may be affected by scanner-specific parameters. Therefore, it is important to verify the effect of different CT scanning protocols on Hounsfield unit (HU) and its impact o...
متن کامل