Noise Optimization Techniques for 1V 1GHz CMOS Low-Noise Amplifiers Design
نویسندگان
چکیده
A 1V, 1GHz low noise amplifier (LNA) has been designed and simulated using Spectre simulator in a standard TSMC 0.18um CMOS technology. With low power and noise optimization techniques, the amplifier provides a gain of 24 dB, a noise figure of only 1.2 dB, power dissipation of 14 mW from a 1 V power supply.
منابع مشابه
Low-Voltage and Low-Noise CMOS Analog Circuits Using Scaled Devices
Recently low-voltage and low-noise analog circuits with sub100nm CMOS devices are strongly demanded for implementing mobile digital multimedia and wireless systems. Reduction of supply voltage makes it difficult to attain a signal voltage swing, and device deviation causes large DC offset voltage and 1/f noise. This paper describes noise reduction technique for CMOS analog and RF circuits opera...
متن کاملDesign of Sub-mW RF CMOS Low-Noise Amplifiers
The quest for low power, low cost, and highly integrated transceivers has gained substantial momentum due to the explosion of wireless applications such as personal area networks and wireless sensor networks. This dissertation presents a comprehensive study and a design methodology for power-efficient CMOS radio-frequency (RF) low-noise amplifiers (LNAs). To demonstrate the design methodology, ...
متن کاملLow Power, Low Noise Amplifiers Design and Analysis for Rf Receiver Front End Using 90nm Cmos Technology Used for Wimax Applications
This work is mainly to ensure the reliability of low power low noise amplifier design and analysis which is useful for 4G receiver front ends in particularly WIMAX applications. The low noise amplifiers implemented by using different topologies namely (a) Cascoded Common source amplifier technique(b) Folded Cascode amplifier technique (c) Shunt feedback amplifier technique (d) Current reuse Com...
متن کاملA 0.6mA, 0.9V 100MHz FM front-end in a 0.18μm CMOS-D technology
A sub-1V analog front-end for the FM 88-108MHz broadcasting band is presented. This front end includes a LNA, two RF amplifiers, I-Q down converters, on chip active polyphase and low-pass filters. An RSSI and limiting amplifiers are included too. The total current consumption is only 600μA for a global NF of 5dB. This front-end is suitable for FM and further RDS demodulation.
متن کاملA W-band Simultaneously Matched Power and Noise Low Noise Amplifier Using CMOS 0.13µm
A complete procedure for the design of W-band low noise amplifier in MMIC technology is presented. The design is based on a simultaneously power and noise matched technique. For implementing the method, scalable bilateral transistor model parameters should be first extracted. The model is also used for transmission line utilized in the amplifier circuit. In the presented method, input/output ma...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2013