Electrochemical characterization of liquid phase exfoliated two-dimensional layers of molybdenum disulfide.

نویسندگان

  • Andrew Winchester
  • Sujoy Ghosh
  • Simin Feng
  • Ana Laura Elias
  • Tom Mallouk
  • Mauricio Terrones
  • Saikat Talapatra
چکیده

We report on the electrochemical charge storage behavior of few-layered flakes of molybdenum disulfide (MoS2) obtained by liquid phase exfoliation of bulk MoS2 powder in 1-dodecyl-2-pyrrolidinone. The specific capacitances of the exfoliated flakes obtained using a 6 M KOH aqueous solution as an electrolyte were found to be an order of magnitude higher than those of bulk MoS2 (∼0.5 and ∼2 mF cm(-2) for bulk and exfoliated MoS2 electrodes, respectively). The exfoliated MoS2 flakes also showed significant charge storage in different electrolytes, such as organic solvents [1 M tetraethylammonium tetrafluoroborate in propylene carbonate (Et4NBF4 in PC)] and ionic liquids [1-butyl-3-methylimidazolium hexafluorophosphate (BMIM-PF6)]. The values of specific capacitances obtained using Et4NBF4 in PC and BMIM-PF6 were ∼2.25 and ∼2.4 mF cm(-2), respectively. An analysis of electrochemical impedance spectroscopy using an equivalent circuit modeling was performed to understand the charge storage mechanism of these exfoliated MoS2 flakes using different electrolytes. Our findings indicate that liquid phase exfoliation methods can be used to produce large quantities of electrochemically active, two-dimensional layers of MoS2 and can act as an ideal material in several applications related to electrochemistry.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Multiscale structural and electronic control of molybdenum disulfide foam for highly efficient hydrogen production

Hydrogen production through water splitting has been considered as a green, pure and high-efficient technique. As an important half-reaction involved, hydrogen evolution reaction is a complex electrochemical process involving liquid-solid-gas three-phase interface behaviour. Therefore, new concepts and strategies of material design are needed to smooth each pivotal step. Here we report a multis...

متن کامل

Ultrasensitive reversible oxygen sensing by using liquid-exfoliated MoS2 nanoparticles

Two-dimensional (2D) molybdenum disulfide (MoS2) has been attracting rapidly increasing interest for application in chemoresistive gas sensors owing to its moderate band gap energy and high specific surface area. However, the mechanism of chemoresistive sensing via the adsorption and desorption of gas molecules and the influence of the shape of 2D materials are not well understood yet. Herein w...

متن کامل

Photoluminescence from chemically exfoliated MoS2.

A two-dimensional crystal of molybdenum disulfide (MoS2) monolayer is a photoluminescent direct gap semiconductor in striking contrast to its bulk counterpart. Exfoliation of bulk MoS2 via Li intercalation is an attractive route to large-scale synthesis of monolayer crystals. However, this method results in loss of pristine semiconducting properties of MoS2 due to structural changes that occur ...

متن کامل

Growth of large-area and highly crystalline MoS2 thin layers on insulating substrates.

The two-dimensional layer of molybdenum disulfide (MoS(2)) has recently attracted much interest due to its direct-gap property and potential applications in optoelectronics and energy harvesting. However, the synthetic approach to obtain high-quality and large-area MoS(2) atomic thin layers is still rare. Here we report that the high-temperature annealing of a thermally decomposed ammonium thio...

متن کامل

Development of Single Walled Carbon Nanotube-Molybdenum Disulfide Nanocomposite/poly-ethylene Glycol Modified Carbon Paste Electrode as an Electrochemical Sensor for the Investigation of Sulfadiazine in Biological Samples

A rapid electrochemical analysis of sulfadiazine (SFZ) has been carried out by cyclic voltammetry (CV) and differential pulse voltammetry (DPV) methods by employing a sensitive single walled carbon nanotube-molybdenum disulfide nanocomposite/poly ethylene glycol modified carbon paste electrode (SWCNT-MoS2/PEG/CPE). The SFZ shows anodic peak potential at 0.94 V (vs. Ag/AgCl) in 0.1 M PBS of pH 7...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • ACS applied materials & interfaces

دوره 6 3  شماره 

صفحات  -

تاریخ انتشار 2014