Effect of hydrophilicity of polyaniline particles on their electrorheology: steady flow and dynamic behaviour.

نویسندگان

  • Martin Stěnička
  • Vladimír Pavlínek
  • Petr Sáha
  • Natalia V Blinova
  • Jaroslav Stejskal
  • Otakar Quadrat
چکیده

Electrorheological properties of suspensions are considerably affected by hydrophilicity of suspension particles. As a model material, polyaniline base powder protonated with sulfamic, tartaric, or perfluorooctanesulfonic acids provided particles of various hydrophilicity. The experiments revealed that, in the absence of electric field, due to a good compatibility of hydrophobic polyaniline particles with silicone-oil medium, their interactions were limited and the viscosity of suspension was low. When the electric field was applied, the rigidity of the polarized chain structure of the particles increased and, consequently, viscosity increased as well. In the contrast, the field-off suspension viscosity of highly interacting hydrophilic particles, which are incompatible with the oil, and where particle aggregation may set in, was high especially at low shear rates, and the material had a pseudoplastic character. Then, a relative increase in viscosity due to the polarization of the particles or their clusters in the electric field was much lower than in the former case. Due to a different primary structure of suspension, depending on the particle compatibility with the oil the field-off storage modulus of suspensions of hydrophobic particles was lower than the loss modulus, while in suspensions of hydrophilic particles the former modulus dominated. In both cases, an increase in elasticity with increasing electric field strength was higher than that in viscosity.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Preparation of polystyrene/polyaniline composite particles and their electrorheology

Monodisperse polystyrene (PS) seed latex was initially prepared by a dispersion polymerization, and then polyaniline (PANI)-coated PS composite particles were synthesized by diffusion and polymerization of aniline at the interface. Characteristics of the obtained PS/PANI composite particles such as morphology and thermal property were examined using SEM and TGA, respectively. In addition, we em...

متن کامل

Fabrication of Polyaniline Coated Snowman-like Pmma Microparticle and Its Electrorheology

Monodisperse anisotropic particles have tremendous potentials in materials science and engineering (Hosein et al., 2010). As one of this kind of materials, snowman-like particles have drawn a special attention in the aspects of both their synthesis mechanism and applications. In this study, we synthesized micron-sized snowman-like poly(methyl methacrylate) (PMMA) particles via a seed emulsion p...

متن کامل

Colloidal graphene oxide/polyaniline nanocomposite and its electrorheology.

A nanocomposite of colloidal graphene oxide (CGO) and polyaniline (PANI) was fabricated via in situ oxidation polymerization in the presence of CGO prepared via a modified Hummers method without a dopant, in which the graphene oxide was individually exfoliated. Its electrorheological properties and other physical characteristics were studied.

متن کامل

Simulation and Control of a Methanol-To-Olefins (MTO) Laboratory Fixed-Bed Reactor

In this research, modeling, simulation, and control of a methanol-to-olefins laboratory fixed-bed reactor with electrical resistance furnace have been investigated in both steady-state and dynamic conditions. The reactor was modeled as a one-dimensional pseudo-homogeneous system. Then, the reactor was simulated at steady-state conditions and the effect of different parameters including...

متن کامل

Preparation of Polyaniline-Clay Nanoadditive and Investigation on Anticorrosion Performance in Epoxy Coating

The corrosion protection of mild steel by a newly developed epoxy-based coating system containing inherently conducting nanopolyaniline-clay as a nanoadditive has been studied. Polyaniline-clay anticorrosion nanoadditive (PCNA) was obtained by the direct mixing method of nanopolyaniline (0.03 wt.%) and organo-modified clay (3 wt.%) at atmospheric pressure, and XRD technique was used to study d-...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Journal of colloid and interface science

دوره 346 1  شماره 

صفحات  -

تاریخ انتشار 2010