The Optimization of Engine Mounting Parts Using Hot-Cold Forging Technology
نویسندگان
چکیده
The purpose of this study is to develop a forging process of automotive parts that satisfies the deformation characteristics. The analyses of temperature variation and deformation behavior of the material are important to obtain the optimal forging products. The hot compression test was carried out to know formability at high temperature. In order to define the optimum forging conditions including material temperature, strain and forging load, the commercial finite element analysis code was used to simulate the forging procedure of engine mounting parts. Experimental results were compared with the simulation results by finite element analysis. Test results were in good agreement with the simulations. Keywords—Cold forging, hot forging, engine mounting, automotive parts, optimization.
منابع مشابه
Optimal characteristics determination of engine mounting system using TRA mode decoupling with emphasis on frequency responses
It is possible to improve vehicle vibration by tuning the parameters of engine mounting system. By optimization of mount characteristics or finding the optimal position of mounts, vibration of the engine and transmitted force from the engine to the chassis can be reduced. This paper examines the optimization of 6-degree-of-freedom engine mounting system based on torque roll axis (TRA) mode deco...
متن کاملPowertrain mounting system optimization to improve vibration behavior for EF7 engine
Improvement and optimization of the Powertrain mounting system are one of the ways to improve the performance NVH cars. The study aims to find the optimal stiffness coefficients for each mount in three directions. The natural frequencies of the system remain steady and stay away from the excitation frequencies, so that the system does not a resonance. It was also, using the decoupling vibration...
متن کاملNumerical and Experimental Investigation of Cold orBital Forging of a 16MnCr5 Alloy Spur Bevel Gear
The purpose of this research is to analyze the forging of bevel gears based on conventional forging method with material number 1.7131 with finite element method by means of SUPER FORGE software and to compare it with experimental cold orbital forging results.After doing simulation of conventional forging and obtaining press tonnage due to orbital forging method with DEFORM software, orbital fo...
متن کاملDetermination of Load and Strain-Stress Distributions in Hot Closed Die Forging Using the Plasticine Modeling Technique
An axisymmetric hot closed die-forging process has been studied by physical modeling technique using the plasticine. To observe the material flow pattern, layers of plasticine with different colors were used. The normal direction to the layers was considered a principal direction. The strain distribution was obtained by measuring the thickness of the plasticine layers. Based on the strain distr...
متن کاملAn Investigation on the Effects of Gas Pressure Drop in Heat Exchangers on Dynamics of a Free Piston Stirling Engine
This paper is devoted to study the effects of pressure drop in heat exchangers on the dynamics of a free piston Stirling engine. First, the dynamic equations governing the pistons as well as the gas pressure equations for hot and cold spaces of the engine are extracted. Then, by substituting the obtained pressure equations into the dynamic relationships the final nonlinear dynamic equations gov...
متن کامل