Dynamic Programming Based Algorithm for the Unit Commitment of the Transmission-Constrained Multi-Site Combined Heat and Power System
نویسندگان
چکیده
Abstract—High penetration of intermittent renewable energy sources (RES) such as solar power and wind power into the energy system has caused temporal and spatial imbalance between electric power supply and demand for some countries and regions. This brings about the critical need for coordinating power production and power exchange for different regions. As compared with the poweronly systems, the combined heat and power (CHP) systems can provide additional flexibility of utilizing RES by exploiting the interdependence of power and heat production in the CHP plant. In the CHP system, power production can be influenced by adjusting heat production level and electric power can be used to satisfy heat demand by electric boiler or heat pump in conjunction with heat storage, which is much cheaper than electric storage. This paper addresses multi-site CHP systems without considering RES, which lay foundation for handling penetration of RES. The problem under study is the unit commitment (UC) of the transmission-constrained multi-site CHP systems. We solve the problem by combining linear relaxation of ON/OFF states and sequential dynamic programming (DP) techniques, where relaxed states are used to reduce the dimension of the UC problem and DP for improving the solution quality. Numerical results for daily scheduling with realistic models and data show that DP-based algorithm is from a few to a few hundred times faster than CPLEX (standard commercial optimization software) with good solution accuracy (less than 1% relative gap from the optimal solution on the average).
منابع مشابه
The Effects of Electricity Boiler on Integrated CCHP-Thermal-Heat Only Unit Commitment Problem Based on Hybrid GA Approach
Combined cooling, heat, and power (CCHP) units can be integrated with conventional separate cooling, heat, and power production units to meet demands. The goal of this study is to develop and examine a hybrid GA-heuristic optimization algorithm for solving the unit commitment problem for integrated CCHP-thermal-heat only system with considerations for electricity boiler. When environmental emis...
متن کاملSecurity Constrained Unit Commitment in the Simultaneous Presence of Demand Response Sources and Electric Vehicles
Due to the ever-growing load, especially peak load, the increase in the capacity of plants is inevitable for the response to this growth. Peak load causes increases in customer costs and vast investments in generating and transmission parts. Therefore, restructuring in the electrical industry, competition in the electrical market and Demand Response Programs (DRPs) are of special importance in ...
متن کاملA dynamic regrouping based sequential dynamic programming algorithm for unit commitment of combined heat and power systems
This paper addresses the unit commitment (UC) in multi-period combined heat and power (CHP) production planning under the deregulated power market. In CHP plants (units), generation of heat and power follows joint characteristics, which implies that it is difficult to determine the relative cost efficiency of the plants. We introduce in this paper the DRDP-RSC algorithm, which is a dynamic regr...
متن کاملDegree of Optimality as a Measure of Distance of Power System Operation from Optimal Operation
This paper presents an algorithm based on inter-solutions of having scheduled electricity generation resources and the fuzzy logic as a sublimation tool of outcomes obtained from the schedule inter-solutions. The goal of the algorithm is to bridge the conflicts between minimal cost and other aspects of generation. In the past, the optimal scheduling of electricity generation resources has been ...
متن کاملA New Algorithm for Optimum Voltage and Reactive Power Control for Minimizing Transmission Lines Losses
Reactive power dispatch for voltage profile modification has been of interest Abstract to powerr utilities. Usually local bus voltages can be altered by changing generator voltages, reactive shunts, ULTC transformers and SVCs. Determination of optimum values for control parameters, however, is not simple for modern power system networks. Heuristic and rather intelligent algorithms have to be so...
متن کامل