Analysis of the thermal environment inside the furnace of a dynamic mechanical analyser
نویسندگان
چکیده
In this work, the thermal environment inside the furnace of a dynamic mechanical analyser was investigated by putting a standard sample in distinct positions inside the furnace. Penetration experiments were carried out in order to compare the measured melting temperature of the sample with the theoretical melting temperature. The thermal gradients were investigated for three distinct modes: compression, three-point bending and extension. In the compression mode a small variation of the measured melting point was found as a function of the radial distance. However, for both extension and three-point bending modes quite important variations were measured along the relevant directions. In the former case the bottom clamp was found to be warmer than the upper one and in the latter mode higher temperatures are found in the extremities of the samples (closer to the furnace wall). Other factors, such as the influence of the heating rate and the purge gas flow rate, were also investigated. In the particular case of the extension mode, it was found that the measured melting temperature decreased with increasing scanning rate. A simple model was used in order to investigate the influence of the temperature gradients on DMA measurements. For temperature gradients along the sample length below 10°C the differences in the viscoelastic parameters (tan d, D∗ and E∗) from the homogeneous case are small when compared with typical experimental errors. 2002 Elsevier Science Ltd. All rights reserved.
منابع مشابه
ANALYSIS OF COMBINED CONDUCTION AND RADIATION HEAT TRANSFER IN A RECTANGULAR FURNACE INCLUDING TWO FLAMES
Abstract: The present study deals the theoretical modeling aspects of coupled conductive and radiative heat transfer in the presence of absorbing, emitting and scattering gray medium within two-dimensional square furnace including two flames. The gray radiative medium is bounded by isothermal walls which are considered to be opaque, diffuse and gray. The well known discrete ordinate method (DOM...
متن کاملDynamic Modeling of a Robot Manipulator for Opening the Tap Hole of an Electric Arc Furnace
The electric arc furnace (EAF) is used to produce high quality steel from steel scraps. The EAF uses plasma arc to generate heat for melting scarp or direct reduced iron (DRI). The liquid metal should be drained from the tap hole. Manual tapping operation of the EAF in the hot environment around the furnace is a potentially dangerous and time consuming task for the workers. Therefore, it is ess...
متن کاملA New Sensitivity Study of Thermal Stress Distribution for a Planar Solid Oxide Fuel Cell
Converting chemical energy into electricity is done by an electro-chemical device known as a fuel cell. Thermal stress is caused at high operating temperature between 700 oC to 1000 oC of SOFC. Thermal stress causes gas escape, structure variability, crack initiation, crack propagation, and cease operation of the SOFC before its lifetime. The aim of this study is to presen...
متن کاملHeat Transfer Calculation in the Firebox of the Ethylene Plant Furnaces (RESEARCH NOTE).
The thermal cracking of hydrocarbons for olefin production is carried out in long tubular reactors inserted in a furnace, in this process the heat flux along the reactor wall determines the feedstock conversion, the olefin selectivity's and rate of coke deposition. A detailed firebox simulation model is therefore a powerful tool in the design and operation of pyrolysis furnaces and reactors to ...
متن کاملAnalysis of Motion of Micro-Gripper Exposed to the Electric Field and Thermal Stresses for Using in Micro-Robotics
Micro system technology is a relatively new scientific research that deals with the development and study of properties of materials in micro dimensions. Micro-grippers are widely used in switching, positioning, and assembling micron sized components in micro-robotics. In this study, the static and dynamic behavior of visco-elastic Micro-Tweezers under the thermal and electrostatic field is...
متن کامل