Nanoindentation of explosive polymer composites to simulate deformation and failure

نویسندگان

  • J. D. Yeager
  • K. J. Ramos
  • S. Singh
  • M. E. Rutherford
  • J. Majewski
  • D. E. Hooks
چکیده

Crack initiation and propagation is a common concern for molecular composites such as plastic bonded explosives (PBXs) and pharmaceutical tablets. Under compressive stresses, cracks form at contacts between crystals and propagate along crystal-binder interfaces, causing composite failure. To investigate this process, crystal-binder interfaces have been characterised and their mechanical properties tested. Here, samples were created with interfaces representative of those in PBXs and characterised with surface energy measurements and neutron reflectometry (NR). Nanoindentation was performed to simulate the deformation and cracking that occurs at crystal– crystal contacts through the binder. NR revealed that use of a plasticiser disrupts typical crystal– binder intermixing and results in a mechanically weaker interface. During nanoindentation, a plasticised binder was observed by atomic force microscopy to delaminate around indentation impressions, whereas a non-plasticised binder did not. Differences in interfacial adhesion and incompatible strain, dictated by the elastic–plastic film compliances, were used to explain the contrasting delamination behaviours.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Macro-Micro Mechanical Behavior of a Highly-Particle-Filled Composite Using Digital Image Correlation Method

Particle reinforced composites represent a large group of materials used in a variety of applications, such as concretes and solid rocket propellant. The mechanical behavior of these materials depends on properties of constitutes and any microstructural changes that may occur in the body under loading. Generally, particles are applied to high stress in these composites. Heterogeneity plays an i...

متن کامل

A Brief Review of Nanoindentation Technique and its Applications in Hybrid Nanocomposite Coatings

Nanoindentation techniques are widely used for the study of nanomechanical properties of thin nanocomposite coatings. Theoretical concepts and practical use of nanoindentation method are summarized with reporting the applications of these tests in characterization of some particular thin nanocomposite hybrid coatings prepared by sol-gel process. The better mechanical properties can be obtained ...

متن کامل

A Brief Review of Nanoindentation Technique and its Applications in Hybrid Nanocomposite Coatings

Nanoindentation techniques are widely used for the study of nanomechanical properties of thin nanocomposite coatings. Theoretical concepts and practical use of nanoindentation method are summarized with reporting the applications of these tests in characterization of some particular thin nanocomposite hybrid coatings prepared by sol-gel process. The better mechanical properties can be obtained ...

متن کامل

Mechanical characterization of polymers on a nanoscale through AFM nanoindentation: A theoretical study on the time-dependent viscoelastic recovery

The temperature-dependent indent recovery of polymer materials was measured by atomic force microscopy (AFM). A numerical model based on the Boussinesq equations was developed to simulate the viscoelastic indent recovery. Viscoelastic solution of stress and displacement is obtained by using the corresponding principle between elasticity and viscoelasticity. The numerical solution provides resul...

متن کامل

Failure Mode and Analysis of the Bonded/bolted Joints between a Hybrid Fibre Reinforced Polymer and Aluminium Alloy

Composites are being used extensively in several engineering applications. However, the efficiency of the joints used in joining composites and metals can be improved. To move towards a sustainable and environment friendly future, natural fibre composite material was used. Towards the above objective, research work was carried out for the assembly between a composite and aluminium. Three differ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2012