Asymmetric magnetosphere deformation driven by hot flow anomaly(ies)
نویسندگان
چکیده
[1] We present a case study of a large deformation of the magnetopause on November 26, 2008. The investigation is based on observations of five THEMIS spacecraft located at the dawn flank in the magnetosphere and magnetosheath, on Cluster measurements at the dusk magnetosheath, and is supported by ACE solar wind monitoring. The main revelation of our study is that the interaction of the IMF discontinuity with the bow shock creates either one very elongated hot flow anomaly (HFA) or a pair of them that is (are) simultaneously observed at both flanks. Whereas the dusk HFA is weak and does not cause observable deformation of the magnetopause, the pressure variations connected with the dawn HFA lead to a magnetopause displacement by ≈5 RE outward from its nominal position. This is followed by a rapid inward motion of the magnetopause ≈4 RE inward with respect to the model location. The surface deformation is so large that the outermost THEMIS spacecraft was in the magnetosphere, whereas the spacecraft located 9 RE inbound entered into the magnetosheath at the same time. The whole event lasted about 5 minutes. Citation: Šafránková, J., O. Goncharov, Z. Němeček, L. Přech, and D. G. Sibeck (2012), Asymmetric magnetosphere deformation driven by hot flow anomaly(ies), Geophys. Res. Lett., 39, L15107, doi:10.1029/2012GL052636.
منابع مشابه
FE-Based Analysis of Hot Forming Process Using the Flow Stress Prediction Model
In hot forming process, the workpiece undergoes plastic deformation at high temperature and the microstructure of the workpiece changes according to the plastic deformation. These changes affect the mechanical properties of workpiece. In order to optimize this process, both the plastic deformation of workpiece and its microstructural changes should be taken into consideration. Since material be...
متن کاملFE-Based Analysis of Hot Forming Process Using the Flow Stress Prediction Model
In hot forming process, the workpiece undergoes plastic deformation at high temperature and the microstructure of the workpiece changes according to the plastic deformation. These changes affect the mechanical properties of workpiece. In order to optimize this process, both the plastic deformation of workpiece and its microstructural changes should be taken into consideration. Since material be...
متن کاملA comparative study on constitutive modeling of hot deformation flow curves in AZ91 magnesium alloy
Modeling the flow curves of materials at elevated temperatures is the first step in mathematical simulation of the hot deformation processes of them. In this work a comparative study was provided to examine the capability of three different constitutive equations in modeling the hot deformation flow curves of AZ91 magnesium alloy. For this, the Arrhenius equation with strain dependent constants...
متن کاملA SVM model to predict the hot deformation flow curves of AZ91 magnesium alloy
Abstract In this work, a support vector machine (SVM) model was developed to predict the hot deformation flow curves of AZ91 magnesium alloy. The experimental stress-strain curves, obtained from hot compression testing at different deformation conditions, were sampled. Consequently, a data base with the input variables of the deformation temperature, strain rate and strain and the output variab...
متن کاملQuantitative analysis of thermo-mechanical behavior in 414 stainless steel using flow curves and processing maps
The hot deformation behavior of a typical martensitic stainless steel containing 2.1% Ni was investigated by means of the compression test in the strain rate range of 0.001-1 s-1 and temperature range of 950-1150 °C. The flow behavior of the steel was evaluated using the flow stress curves and flow softening map and by microstructural investigation. Taking into account of the strain effect on t...
متن کامل