Simulation of Aerodynamics and Combustion in Open Swirl Flow

نویسندگان

  • Q. W. Zhao
  • C. K. Chan
  • H. F. Zhao
چکیده

Flame stabilization by swirl is a common feature of many combustors. While most of the swirl combustors are enclosed, there have been relatively few studies of open swirl-stabilized flames. In the current study, an open swirl-stabilized turbulent premixed flame is studied numerically. The purpose of this work is to obtain a better understanding of the flame properties by simulating the flow field, combustion and heat transfer. Spalding’s stretch-cut-slide model is extended to determine the mixing controlled fuel burning rate per unit volume, Sfu,T , which is defined by           + ∂ ∂ + ∂ ∂ − = o L o fu fu,T /l S x v y u 5 . 0 i M , M min ñ S 2 . The results are comparable to previous studies. Intense combustion occurs in a narrow region. A stationary planar flame is maintained above the burner exit, where the turbulent flame speed is equal to local flow velocity. Although the flame is stabilized by swirl, the flame zone is in fact free of swirl. Predictions reveal that flame stabilization does not rely on recirculation, but on flow divergence, though a recirculation zone is located downstream of the flame. It is noted that the recirculation zone becomes wider and longer under combustion than in cold swirling jets. Apart from an increase of adverse pressure gradient, the decrease in turbulent diffusion tends to increase recirculation in the open system. The strong impingement between swirling jet and reverse flow makes the flame planar. Introduction The necessity to ensure stability and high combustion efficiency and to localize the flame in a given part of the combustion space requires the use of special methods of flow organization. The main principle of combustion stabilization is to create a region where the local velocity is equal to the flame propagation velocity. This is achieved either using a stabilizer in the form of a bluff body, or by means of swirl. Flame stabilization by the latter is a common feature of many combustors and many fundamental aspects of the complex interaction between swirl and flames have been studied experimentally and theoretically. However, most of the swirl combustors are enclosed, and there has been relatively few studies of open turbulent swirl stabilized flames.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

On the Dependence of Soot Formation and Combustion on Swirling Combustion Furnaces: Measurement and Simulation

Soot concentration distribution is investigated both numerically and experimentally in methane-air diffusion flame. The experimental work is conducted with a cylindrical swirl stabilized combustor. Filter paper technique is used to measure soot volume fraction inside the combustor. The numerical simulation is based on the solution of the fully-coupled conservation equations for swirling turbule...

متن کامل

Numerical Investigation of Flow Field of D87 Dual Fuel Engine

A newly developed heavy duty diesel engine in dual fuel mode of operation has been studied in detail. The main fuel would be natural gas and diesel oil as pilot injection. The importance and effects of mixture preparation and formation through ports, valves and in cylinder flow field with different swirl ratio and tumble on diesel combustion phenomena is an accepted feature which has been studi...

متن کامل

Effect of Swirl on Gas-Fired Combustion Behavior in a 3-D Rectangular Combustion Chamber

The objective of this work is to investigate the turbulent reacting flow in a three dimensional combustor with emphasis on the effect of inlet swirl flow through a numerical simulation. Flow field is analyzed using the SIMPLE method which is known as stable as well as accurate in the combustion modeling, and the finite volume method is adopted in solving the radiative transfer equation. In this...

متن کامل

Effect of swirl on combustion dynamics in a lean-premixed swirl-stabilized combustor

The effect of inlet swirl on the flow development and combustion dynamics in a lean-premixed swirl-stabilized combustor has been numerically investigated using a large-eddy-simulation (LES) technique along with a level-set flamelet library approach. Results indicate that when the inlet swirl number exceeds a critical value, a vortex-breakdown-induced central toroidal recirculation zone is estab...

متن کامل

CFD Insight of the Flow Dynamics and Velocity Fields in a Gas Turbine Combustor with a Swirl Flame

The computational fluid dynamics (CFD) simulations of gas turbine combustor were performed for CH4<span st...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2000