Design, modelling and characterisation of impact based and non-contact piezoelectric harvesters for rotating objects
نویسنده
چکیده
FACULTY OF PHYSICAL AND APPLIED SCIENCES SCHOOL OF ELECTRONICS AND COMPUTER SCIENCE Doctor of Philosophy DESIGN, MODELLING AND CHARACTERISATION OF IMPACT BASED AND NON-CONTACT PIEZOELECTRIC HARVESTERS FOR ROTATING OBJECTS
منابع مشابه
Analytical Solution for Electro-mechanical Behavior of Piezoelectric Rotating Shaft Reinforced by BNNTs Under Non-axisymmetric Internal Pressure
In this study, two-dimensional electro-mechanical analysis of a composite rotating shaft subjected to non-axisymmetric internal pressure and applied voltage is investigated where hollow piezoelectric shaft reinforced by boron nitride nanotubes (BNNTs). Composite structure is modeled based on piezoelectric fiber reinforced composite (PFRC) theory and a representative volume element has been cons...
متن کاملDesign and Construction of a Novel Tactile Sensor for Measuring Contact-Force, Based on Piezoelectric Effect
In this paper, design and construction of a tactile sensor for measuring contact-force is presented. Mechanism of measuring contact-force in this tactile sensor is based on impedance changing of piezoelectric crystal and voltage of different points in circuit as a result of applying force on the crystal. By considering a specific point in the circuit and recording the changes of its voltage, ma...
متن کاملImproving Power Density of Piezoelectric Vibration-Based Energy Scavengers
Vibration energy harvesting with piezoelectric materials currently generate up to 300 microwatts per cm2, using it to be mooted as an appropriate method of energy harvesting for powering low-power electronics. One of the important problems in bimorph piezoelectric energy harvesting is the generation of the highest power with the lowest weight. In this paper the effect of the shape and geometry ...
متن کاملShape Design Optimization of Unimorph Piezoelectric Cantilever Energy Harvester
The most promising method for micro scale energy scavenging is via vibration energy harvesting which converts mechanical energy to electrical energy. Using piezoelectric cantilevers is the most common method for vibration energy harvesting. Changing the shape of the cantilevers can lead to changing the generated output voltage and power. In this work vibration energy harvesting via piezoelectri...
متن کامل3D Modelling of Under Ground Burried Objects Based on Ground Penetration Radar
There is a growing demand for mapping and 3D modelling of buried objects such as pipelines, agricultural hetitage, landmines and other buried objects. Usually, large scale and high resolution maps from these objects are needed. Manually map generation and modeling of these objects are cost and time consuming and is dependent on lots of resources. Therefore, automating the subsurface mapping and...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2010