Direct Measurements of Reynolds Stresses and Turbulence in the Bottom Boundary Layer
نویسندگان
چکیده
b. Quantify the temporal variation of turbulent stresses, turbulence production, dissipation and spectra in relation to the oceanographic parameters that represent the local environment, such as waves, currents, vertical density gradient, internal waves and the nature of the water-sediment interface. The conclusions will quantify the relative importance of different mechanisms that control the flow and turbulence in the benthic boundary layer.
منابع مشابه
Study of Parameters Affecting Separation Bubble Size in High Speed Flows using k-ω Turbulence Model
Shock waves generated at different parts of vehicle interact with the boundary layer over the surface at high Mach flows. The adverse pressure gradient across strong shock wave causes the flow to separate and peak loads are generated at separation and reattachment points. The size of separation bubble in the shock boundary layer interaction flows depends on various parameters. Reynolds-averaged...
متن کاملDistribution of Energy Spectra, Reynolds Stresses, Turbulence Production, and Dissipation in a Tidally Driven Bottom Boundary Layer
Seven sets of 2D particle image velocimetry data obtained in the bottom boundary layer of the coastal ocean along the South Carolina and Georgia coast [at the South Atlantic Bight Synoptic Offshore Observational Network (SABSOON) site] are examined, covering the accelerating and decelerating phases of a single tidal cycle at several heights above the seabed. Additional datasets from a previous ...
متن کاملInteraction layer between a turbulent boundary layer and free-stream turbulence
The interaction between a turbulent free-stream and a turbulent boundary layer is investigated through particle image velocimetry measurements. An ‘interaction layer’ located between 0.12 ≤ y/δ ≤ 0.19, at the end of the log layer, is identified whereby the kinetic energy in this layer describes the flow above it. Conditional averages about the interaction layer indicate that it is home to peaks...
متن کاملNumerical Simulation of Separation Bubble on Elliptic Cylinders Using Three-equation k-? Turbulence Model
Occurrence of laminar separation bubbles on solid walls of an elliptic cylinder has been simulated using a recently developed transitional model for boundary layer flows. Computational method is based on the solution of the Reynolds averaged Navier-Stokes (RANS) equations and the eddy-viscosity concept. Transitional model tries to simulate streamwise fluctuations, induced by freestream turbulen...
متن کاملDevelopment of a Low Cost and Safe PIV for Mean Flow Velocity and Reynolds Stress Measurements
In this study, a white light particle image velocimetry (WL PIV) system which employs a light sheet generated with a flash was used. The system was developed in order to provide a cost-efficient and safe alternative to laser systems while keeping the accuracy limits required for hydraulic model tests. To investigate the accuracy of WL PIV method under different flow conditions, experiments were...
متن کامل