The Goodwin Model: Behind the Hill Function

نویسندگان

  • Didier Gonze
  • Wassim Abou-Jaoudé
چکیده

The Goodwin model is a 3-variable model demonstrating the emergence of oscillations in a delayed negative feedback-based system at the molecular level. This prototypical model and its variants have been commonly used to model circadian and other genetic oscillators in biology. The only source of non-linearity in this model is a Hill function, characterizing the repression process. It was mathematically shown that to obtain limit-cycle oscillations, the Hill coefficient must be larger than 8, a value often considered unrealistic. It is indeed difficult to explain such a high coefficient with simple cooperative dynamics. We present here molecular models of the standard Goodwin model, based on single or multisite phosphorylation/dephosphorylation processes of a transcription factor, which have been previously shown to generate switch-like responses. We show that when the phosphorylation/dephosphorylation processes are fast enough, the limit-cycle obtained with a multisite phosphorylation-based mechanism is in very good quantitative agreement with the oscillations observed in the Goodwin model. Conditions in which the detailed mechanism is well approximated by the Goodwin model are given. A variant of the Goodwin model which displays sharp thresholds and relaxation oscillations is also explained by a double phosphorylation/dephosphorylation-based mechanism through a bistable behavior. These results not only provide rational support for the Goodwin model but also highlight the crucial role of the speed of post-translational processes, whose response curve are usually established at a steady state, in biochemical oscillators.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Effect of Stress Triaxiality on Yielding of Anisotropic Materials under Plane Stress Condition

The triaxiality of the stress state is known to greatly influence the amount of plastic strain which a material may undergo before ductile failure occurs. It is defined as the ratio of hydrostatic pressure, or mean stress, to the von Mises equivalent stress. This paper discusses the effects of stress triaxiality on yielding behavior of anisotropic materials. Hill-von Mises’s criteria for anisot...

متن کامل

Comparison of Genetic and Hill Climbing Algorithms to Improve an Artificial Neural Networks Model for Water Consumption Prediction

No unique method has been so far specified for determining the number of neurons in hidden layers of Multi-Layer Perceptron (MLP) neural networks used for prediction. The present research is intended to optimize the number of neurons using two meta-heuristic procedures namely genetic and hill climbing algorithms. The data used in the present research for prediction are consumption data of water...

متن کامل

Earth Pressure behind an Integral Bridge Abutment and Comparison with that behind a Conventional Bridge Abutment under Traffic Loads

 Integral bridges are gaining increased popularity because of both economic and fast construction associated with the omission of bearing supports and expansion joints. In the present study the cyclic earth pressure behind integral bridge abutments under traffic surcharges are investigated and compared with that induced behind the abutment of  conventional bridges (with isolated deck and abutme...

متن کامل

Typology of Earth-shelter Architecture in Iran

Earth-Shelter construction is one of the aspects in architecture where the thermal mass of the earth behind the outer walls are applied in order to reduce heat loss and keep the internal temperature at human comfort range. In case of earth-shelter buildings, housing is especially important. As for its applicability the earth-shelter provides good housing. Typological studies of earth-shelter co...

متن کامل

Stochastic extension of cellular manufacturing systems: a queuing-based analysis

Clustering parts and machines into part families and machine cells is a major decision in the design of cellular manufacturing systems which is defined as cell formation. This paper presents a non-linear mixed integer programming model to design cellular manufacturing systems which assumes that the arrival rate of parts into cells and machine service rate are stochastic parameters and descri...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره 8  شماره 

صفحات  -

تاریخ انتشار 2013