Accurate Low-Current Measurement Circuit for Multimeters and Oscillograps
نویسندگان
چکیده
A simple and high-precision current-to-voltage (I/V) converter circuit for multimeters and oscillographs is presented in this paper. The I/V converter measures the electric current with uA and nA selectable ranges in the frequency range from direct current to 1MHz. Circuit technology is also discussed. System Architecture is presented and dual polarity power is designed. Power detector circuit is explained. Measurement data are obtained. Linearity and the error are analyzed. The typical accuracy of the μCurrent is higher by 0.085% in the μA and nA ranges. μCurrent can be used in detecting low uA and nA in current systems, chips, and modules.
منابع مشابه
Design Modification of Rogowski Coil for Current Measurement in Low Frequency
The principle object of this paper is to offer a modified design of Rogowski coil based on its frequency response. The improvement of the integrator circuit for nullifying the phase difference between the waveforms of the measured-current and the corresponding terminal voltage is a further object of this investigation. This paper addresses an accurate, yet more efficient measuring and protect...
متن کاملHigh-Accurate Low-Voltage Analog CMOS Current Divider Modify by Neural Network and TLBO Algorithm
A high accurate and low-voltage analog CMOS current divider which operates with a single power supply voltage is designed in 0.18µm CMOS standard technology. The proposed divider uses a differential amplifier and transistor in triode region in order to perform the division. The proposed divider is modeled with neural network while TLBO algorithm is used to optimize it. The proposed optimiza...
متن کاملHigh-Accurate Low-Voltage Analog CMOS Current Divider Modify by Neural Network and TLBO Algorithm
A high accurate and low-voltage analog CMOS current divider which operates with a single power supply voltage is designed in 0.18µm CMOS standard technology. The proposed divider uses a differential amplifier and transistor in triode region in order to perform the division. The proposed divider is modeled with neural network while TLBO algorithm is used to optimize it. The proposed optimiza...
متن کاملOptimal Current Meter Placement for Accurate Fault Location Purpose using Dynamic Time Warping
This paper presents a fault location technique for transmission lines with minimum current measurement. This algorithm investigates proper current ratios for fault location problem based on thevenin theory in faulty power networks and calculation of short circuit currents in each branch. These current ratios are extracted regarding lowest sensitivity on thevenin impedance variations of the netw...
متن کاملA Low Cost Sensorless Control Drive Circuit for of Low Voltage Switched Reluctance Motor
Shaft position sensing is an essential part of switched reluctance (SR) motor drive In order to synchronize the pulses of phase current with the period of rising inductance of the proper motor phase. Direct sensors such as, Hall effect and optical encoder are commonly used in SR motors. The purpose of this paper is to present an indirect shaft positioning sensing known as "sensorless " control ...
متن کامل