Graphene flakes under controlled biaxial deformation
نویسندگان
چکیده
Thin membranes, such as monolayer graphene of monoatomic thickness, are bound to exhibit lateral buckling under uniaxial tensile loading that impairs its mechanical behaviour. In this work, we have developed an experimental device to subject 2D materials to controlled equibiaxial strain on supported beams that can be flexed up or down to subject the material to either compression or tension, respectively. Using strain gauges in tandem with Raman spectroscopy measurements, we monitor the G and 2D phonon properties of graphene under biaxial strain and thus extract important information about the uptake of stress under these conditions. The experimental shift over strain for the G and 2D Raman peaks were found to be in the range of 62.3 ± 5 cm(-1)/%, and 148.2 ± 6 cm(-1)/%, respectively, for monolayer but also bilayer graphenes. The corresponding Grüneisen parameters for the G and 2D peaks were found to be between 1.97 ± 0.15 and 2.86 ± 0.12, respectively. These values agree reasonably well with those obtained from small-strain bubble-type experiments. The results presented are also backed up by classical and ab initio molecular dynamics simulations and excellent agreement of Γ-E2g shifts with strains and the Grüneisen parameter was observed.
منابع مشابه
Deformation of Wrinkled Graphene
The deformation of monolayer graphene, produced by chemical vapor deposition (CVD), on a polyester film substrate has been investigated through the use of Raman spectroscopy. It has been found that the microstructure of the CVD graphene consists of a hexagonal array of islands of flat monolayer graphene separated by wrinkled material. During deformation, it was found that the rate of shift of t...
متن کاملMrsec Seminar Seri Es
Graphene is a 2D material with atomic thickness and possesses unusual thermal, electrical, optical, and mechanical properties. However, those predicted, or measured, material properties could be achieved only when graphene has low defects with controlled surrounding environments. In this presentation, I will introduce two major strategies of graphene synthesis from my group; nonoxidized graphen...
متن کاملPreparation of surface coatings on a conductive substrate by controlled motion of graphene nanoflakes in a liquid medium
Controlled motion of graphene and graphene oxide nanoflakes in a thin liquid film on metal surfaces was studied to unravel the significant variations of the electric field effects on the nanoparticles. It was found that graphene oxide flakes were negatively charged and migrated toward anode while the electrically neutral graphene flakes moved toward cathode. Therefore, thin layers of graphene a...
متن کاملSynergistic toughening of composite fibres by self-alignment of reduced graphene oxide and carbon nanotubes
The extraordinary properties of graphene and carbon nanotubes motivate the development of methods for their use in producing continuous, strong, tough fibres. Previous work has shown that the toughness of the carbon nanotube-reinforced polymer fibres exceeds that of previously known materials. Here we show that further increased toughness results from combining carbon nanotubes and reduced grap...
متن کاملVertically-aligned graphene flakes on nanoporous templates: morphology, thickness, and defect level control by pre-treatment
Various morphologies of the vertically-aligned graphene flakes were fabricated on the nanoporous templates treated with metal ions in solutions, as well as coated with a thin gold layer and activated in the low-temperature Ar plasma. The thickness and level of structural defects in the graphene flakes could be effectively controlled by a proper selection of the pre-treatment method. We have als...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره 5 شماره
صفحات -
تاریخ انتشار 2015