Control of Plasma Poloidal Shape and Position in the Diii–d Tokamak
نویسندگان
چکیده
DISCLAIMER This report was prepared as an account of work sponsored by an agency of the United States Government. Neither the United States Government nor any agency thereof, nor any of their employees, makes any warranty, express or implied, or assumes any legal liability or responsibility for the accuracy, completeness, or usefulness of any information, apparatus, produce, or process disclosed, or represents that its use would not infringe privately owned rights. Reference herein to any specific commercial product, process, or service by trade name, trademark, manufacturer, or otherwise, does not necessarily constitute or imply its endorsement, recommendation, or favoring by the United States Government or any agency thereof. The views and opinions of authors expressed herein do not necessarily state or reflect those of the United States Government or any agency thereof.
منابع مشابه
First-Principles-Driven Model-Based Control of the Poloidal Magnetic Flux Profile at the DIII-D Tokamak
Efficient, high-gain operation of a tokamak device requires the achievement of certain radial shapes for the toroidal current profile. The evolution in time of the toroidal current profile in tokamaks is related to the evolution of the poloidal magnetic flux profile. A model-based control approach for the regulation of the poloidal magnetic flux profile at the DIII-D tokamak is proposed in this...
متن کاملCalculation of impurity poloidal rotation from measured poloidal asymmetries in the toroidal rotation of a tokamak plasma.
To improve poloidal rotation measurement capabilities on the DIII-D tokamak, new chords for the charge exchange recombination spectroscopy (CER) diagnostic have been installed. CER is a common method for measuring impurity rotation in tokamak plasmas. These new chords make measurements on the high-field side of the plasma. They are designed so that they can measure toroidal rotation without the...
متن کاملSignature of turbulent zonal flows observed in the DIII-D tokamak.
The spectrum of turbulent density fluctuations at long poloidal wavelengths in the edge plasma of the DIII-D tokamak peaks at nonzero radial wave number. The associated electric-potential fluctuations cause sheared E x B flows primarily in the poloidal direction. These zonal flows have been predicted by theory and are believed to regulate the overall level of turbulence and anomalous transport....
متن کاملModel of real time ITER plasma position, shape and current control on base of DINA code
Poloidal field magnetic control in tokamak has the essential functions of stabilizing the vertical instability inherent in elongated cross-sections, and in keeping the plasma shape, position and current nearly reference even in presence of internal plasma disturbances such as sawteeth, minor disruptions, ELMs and other transients. Poloidal magnetic control comprises in adjusting of the tokamak ...
متن کاملPlasma vertical stabilization with actuation constraints in the DIII-D tokamak
In the advanced tokamak (AT) operating mode of the DIII-D tokamak, an integrated multivariable controller takes into account highly coupled influences of plasma equilibrium shape, profile, and stability control. Time-scale separation in the system allows a multi-loop design: the inner loop closed by the nominal vertical controller designed to control a linear exponentially unstable plant and th...
متن کاملSimulating the ITER Plasma Startup Scenario in the DIII-D Tokamak
€ I /aB, the original 15 MA ITER baseline rampup in 110 s scales to 1.7 MA in 2.2 s for DIII-D. For the large-bore ITER scenario, discussed below, a faster ramp is specified corresponding to 1.64 MA in 1.6 s in DIII-D. In DIII-D, there are three poloidal bumper limiters on the LFS, extending 2 cm from the surrounding graphite wall tiles. In DIII-D, the original ITER startup baseline scenario ha...
متن کامل