Effect of thin aluminum interlayer on growth and microstructure of carbon nanotubes
نویسندگان
چکیده
The aluminum (Al) interlayer with various thicknesses ranging from 0.75 to 6 nm was deposited on silicon (Si) substrates prior to the deposition of ultra-thin iron (Fe) catalyst for the growth of carbon nanotubes. In this paper we report the effect of ultra-thin Al interlayer on the growth of multiwalled carbon nanotubes (MWCNTs). The SEM was used to examine the microstructures of nanotubes. We observed as the Al interlayer thickness increases the height of nanotube decreases. Raman spectra of MWCNT showed typical D and G peaks at 1345 cm 1 and 1575 cm , respectively. The XPS revealed the presence of Al and Fe on the top of CNT surface which were further supported by TEM. The high resolution TEM results also revealed bamboo like CNTs with diameter 10–40 nm. 2009 Elsevier B.V. All rights reserved.
منابع مشابه
Effect of Interlayer Composition on the Microstructure and Mechanical Properties of 1050 Aluminium to St14 Carbon Steel Joint Via Resistance Spot Welding Method
Effect of Interlayer Composition on the Microstructure and Mechanical Properties of 1050 Aluminium to St14 Carbon Steel Joint Via Resistance Spot Welding Method.
متن کاملEvaluation of the Effect of Ni-Co NPs for the Effective Growth of Carbon Nanotubes by TCVD System
A systematic study was conducted to understand the influences of catalyst combination as Ni-Co NPs on carbon nanotubes (CNTs) grown by Chemical Vapor Deposition (TCVD). The DC-sputtering system was used to prepare Co and Ni-Co thin films on silicon substrate. Ni- Co nanoparticles were used as metal catalyst for growing carbon nanotubes from acetylene (C2H2) gas in 850 ̊ C during 15 min. Carb...
متن کاملOptimized Conditions for Catalytic Chemical Vapor Deposition of Vertically Aligned Carbon Nanotubes
Here, we have synthesized vertically aligned carbon nanotubes (VA-CNTs), using chemical vapor deposition (CVD) method. Cobalt and ethanol are used as the catalyst and the carbon source, respectively. The effects of ethanol flow rate, thickness of Co catalyst film, and growth time on the properties of the carbon nanotube growth are investigated. The results show that the flow rate of ethanol and...
متن کاملThe Effect of the AA7075 Interlayer on the Microstructure and Mechanical Properties of the AA1050 Butt Joint Welded by FSW
In this research, the FSW Butt joint of commercial aluminum 1050 was investigated by using the 7075 aluminum alloy interlayer on the linear velocity of 30, 50 and 100 mm / min, and rotational speeds of 800 and 1200 rpm. A threaded cylindrical tool was used for joining of the 5 mm sheets. The OM, SEM, microhardness and tensile tests were done. The results shows that in sample with an interlayer ...
متن کاملThe Effect of the AA7075 Interlayer on the Microstructure and Mechanical Properties of the AA1050 Butt Joint Welded by FSW
In this research, the FSW Butt joint of commercial aluminum 1050 was investigated by using the 7075 aluminum alloy interlayer on the linear velocity of 30, 50 and 100 mm / min, and rotational speeds of 800 and 1200 rpm. A threaded cylindrical tool was used for joining of the 5 mm sheets. The OM, SEM, microhardness and tensile tests were done. The results shows that in sample with an interlayer ...
متن کامل