Application of Smes Unit to Improve the Voltage Profile of the System with Dfig during Grid Dip and Swell
نویسندگان
چکیده
One of the most important parameters of the system where wind turbine generators (WTGs) are connected is voltage profile at the point of common coupling (PCC). In the earlier stage, WTGs were possible to be disconnected from the system to avoid the damage of WTGs. Following the rapid injection of WTGs to the existing network during last decades, the transmission line operators (TSOs) require WTGs to stay connected in certain level of fault to continue support the grid. This new requirements have been compiled in new international grid codes. In this paper, superconducting magnetic energy storage (SMES) is applied to improve the voltage profile of PCC bus where WTGs equipped with doubly fed induction generator (DFIG) is connected to meet the used gird codes of Spain and German during grid dip and swell. The voltage dip at the grid side is examined to comply with the low voltage ride through (LVRT) while the voltage swell at the grid side is examined to comply with the high voltage ride through (HVRT) of both Spain and German voltage ride through (VRT).
منابع مشابه
Improvement of Transient Voltage Profile Using Power Control of the DFIG-Based Wind Farm Under Severe Voltage Dip Event
Improving transient voltage stability is one of the most important issues that must be provided by doubly fed induction generator (DFIG)-based wind farms (WFs) according to the grid code requirement. This paper proposes adjusted DC-link chopper based passive voltage compensator and modified transient voltage controller (MTVC) based active voltage compensator for improving transient voltage stab...
متن کاملLow Voltage Ride-Through Capability Improvement of Doubly Fed Induction Generator using DVR and SMES
Abstract: With the growth of communities and the increasing need for electricity, and because of the many benefits of renewable energy sources, the wind turbine has become a completely commercial and inevitable process, with increasing penetration into the electricity grid. Distribution networks, on the other hand, are subject to fault that cause power fluctuations and outflow of wind units. In...
متن کاملEnhancement Of Fault Ride Through of DFIG Based Wind Energy Conversion System With The Application of SMES
-Doubly Fed Induction Generators (DFIGs)find a great deal of application among variable speed wind turbines because of their advantages like operation at variable speed, ability to produce active and reactive power in all the four quadrants, higher efficiency, and extracting maximum electric power at different velocities of wind with the help of speed variation of the rotor and the usage of con...
متن کاملGA-Based Optimal LQR Controller to Improve LVRT Capability of DFIG Wind Turbines
Nowadays, the doubly-fed induction generators (DFIGs) based wind turbines (WTs) are the dominant type of WTs connected to grid. Traditionally the back-to-back converters are used to control the DFIGs. In this paper, an Indirect Matrix Converter (IMC) is proposed to control the generator. Compared with back-to-back converters, IMCs have numerous advantages such as: higher level of robustness, re...
متن کاملControl of DVR by Fuzzy Controller to Improve Voltage in Distribution System
With the development of critical loads, power quality problem has become particularly important and poor power quality will be cause many adverse effects and the cost of many deaths will follow. To improve power quality and protection of sensitive loads against grid disturbances have been used new equipment based on power electronics similar FACTs devices, they are Custom Power. One of the most...
متن کامل