Maximum Output Power of Class E Amplifier for a Given Transistor, Operating Frequency, and DC Supply Voltage

نویسندگان

  • Takeshi Yasukouchi
  • Tadashi Suetsugu
چکیده

This paper analyzes maximum output power of class E amplifier with arbitrary transistor. It is important to estimate maximum output power of class E amplifier when a specification of transistor is given. In this paper, values of circuit parameters that gives maximum output power for given operating frequency, dc supply voltage, and output capacitance of the transistor are calculated. This paper presents scheme to calculate circuit parameters that maximum output power in this condition. Finally, some example calculations are shown when this scheme was applied to some actual power MOSFET transistors. Keyword: Class E amplifier, Maximum output power, Transistor, Sub class E operation

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

A Class E Power Amplifier with Low Voltage Stress

A new output structure for class E power amplifier (PA) is proposed in this paper. A series LC resonator circuit, tuned near the second harmonic of the operating frequency is added to the output circuit. This resonator causes low impedance at the second harmonic. The output circuit is designed to shape the switch voltage of the class E amplifier and lower the voltage stress of the transistor. T...

متن کامل

Development of High-power High-voltage Dc Power Supply Based on Series Resonant

High-power high-voltage dc power supply has been developed based on series resonant converter technology for a MW class RF amplifier. For low-voltage ripple, an IGBT inverter consisting of 1400 V-600 A devices is drives with a maximum switching frequency of 31.2 kHz. A performance test was carried out using an RF amplifier. We examined this power supply under two different conditions. One was w...

متن کامل

High-Efficiency Power Amplifier Using Dynamic Power-Supply Voltage for CDMA Applications

Efficiency and linearity of the microwave power amplifier are critical elements for mobile communication systems. This paper discusses improvements in system efficiency that are obtainable when a dc–dc converter is used to convert available battery voltage to an optimal supply voltage for the output RF amplifier. A boost dc–dc converter with an operating frequency of 10 MHz is demonstrated usin...

متن کامل

A Low-Voltage, Low-Power, Two-Stage Amplifier for Switched-Capacitor Applications in 90 nm CMOS Process

Abstract- A novel low-voltage two-stage operational amplifier employing resistive biasing is presented. This amplifier implements neutralization and correction common mode stability in second stage while employs capacitive dc level shifter and coupling between two stages. The structure reduces the power consumption and increases output voltage swing. The compensation is performed by simple mill...

متن کامل

A Class E Power Amplifier with Low Voltage Stress

A new output structure for class E power amplifier (PA) is proposed in this paper. A series LC resonator circuit, tuned near the second harmonic of the operating frequency is added to the output circuit. This resonator causes low impedance at the second harmonic. The output circuit is designed to shape the switch voltage of the class E amplifier and lower the voltage stress of the transistor. T...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2008