Prediction of Slag Occurrence in a Lignite-Fired Utility Boiler
نویسنده
چکیده
Lignite from Mae Moh mine is the largest source of solid fuel for electricity generation in Thailand. It is used in pulverized coal-fired boilers of a 2400 MW thermal power plant. Its high CaO content in ash is a major concern that can affect severe slagging. In this paper, potential of slag occurrence in the power plant was investigated by numerical simulation. The FactSage thermochemical package was used to predict ash and slag behaviour, as well as ash fusion temperature. A commercial CFD package was also employed to simulate gas velocity and temperature distribution, particle trajectory and temperature, and wall heat flux in a utility boiler of the power plant. The results were found to show good quantitatively and qualitatively prediction of slag formation. They can be applied to predict slag deposition inside the boiler effectively. Key-Words: slag, lignite, pulverized coal-fired boiler, coal combustion, FactSage simulation, CFD simulation
منابع مشابه
Increasing reliability using FEM–CFD
www.worldpumps.com 0262 1762/08 © 2008 Elsevier Ltd. All rights reserved Effective simulations to ensure optimal performance and correctly predict the hydraulic and thermomechanical behaviour of today’s huge boiler feed water pumps are a challenge for engineers and constructors. Generally, boiler feed water pumps are subjected to extreme mechanical and thermal stresses because of their huge siz...
متن کاملEconomics of Removal of Coal Moisture in Thermal Power Generation with Waste Heat Recovery
The techno-economic aspects of coal drying with cost effective waste heat recovery mechanism is one of the challenging issues faced while using lignite or high ash brown coal for direct combustion in coal fired thermal power plant. Coal being hygroscopic in nature, re-adsorbs considerable moisture even after conventional drying post wet coal washing condition affecting boiler performance. Parti...
متن کاملAsh Fouling Monitoring and Key Variables Analysis for Coal Fired Power Plant Boiler
Ash deposition on heat transfer surfaces is still a significant problem in coal-fired power plant utility boilers. The effective ways to deal with this problem are accurate on-line monitoring of ash fouling and soot-blowing. In this paper, an online ash fouling monitoring model based on dynamic mass and energy balance method is developed and key variables analysis technique is introduced to stu...
متن کاملA GIS-aided resource estimation of coalfields in Kangal basin, Sivas province, Turkey
This paper presents the procedures used for determining and defining the tonnage and grade of the coalfields of Kangal basin from the developed GIS-aided block model. In this work, firstly, all the lithological logs of drill holes and chemical analysis data of core in the basin were analyzed with the help of geostatistics, and then the digital raster maps of each one of the attributes such as t...
متن کاملThe use of equilibrium thermodynamic models for the prediction of inorganic phase changes in the co-firing of wheat straw with El Cerrejon coal
The combustion of pulverised coal in power stations results in slagging and fouling in the boiler section and this can be a more severe problem when co-fired with biomass, especially straw. Prediction of the effects of different combination of biomass and coal are helpful to the plant operators. Predictive software gives information about the onset and nature of the slag formed but often the re...
متن کامل