Determination of sulfur trioxide in engine exhaust.
نویسنده
چکیده
Sulfur trioxide in the exhaust gas of an internal combustion engine is removed and concentrated by absorption in a solution of 80% isopropyl alcohol, which quantitatively absorbs it and inhibits the oxidation of any sulfur dioxide which may be absorbed. The absorbed sulfur trioxide (sulfuric acid) is determined by an absorption titration by using barium chloride as the titrant and thorin as the indicator. The sulfur dioxide content of the exhaust is measured continuously by means of a DuPont Model 411 ultraviolet photoanalyzer.
منابع مشابه
An Investigation of Methods of Producing Sulfur Trioxide in Jet Exhausts through Addition of Fuel Additives to Jp4
i Work was performed to determine the possible effectiveness of sulfur-containing fuel additives as contrail suppressents. Such suppression would require production of significant levels of sulfur trioxide, a known suppressent, in the exhaust. A model combustor capable of simulating turbojet operation at 40,000 feet was designed and built, and a gas sampling and analysis procedure developed for...
متن کاملInvestigation of the Effect of Exhaust Gas Recirculation (EGR) on pollutants Emission From Si Engine Exhaust Gasese (RESEARCH NOTES)
This paper reports the results of an experimental investigation on the effect of the EGR on the pollutants emission, especially on oxides of nitrogen, from the exhaust gases and performance of the spark ignition engine. Also along with experimental work, a mathematical model for the determination of the effect of EGR on the peak cycle temperature and for the prediction of its effect on the NOx ...
متن کاملGaseous SO3 and H2SO4 in the exhaust of an aircraft gas turbine engine: measurements by CIMS and implications for fuel sulfur conversion to sulfur (VI) and conversion of SO3 to H2SO4
An estimation of the conversion efficiency (e) of fuel sulfur to SO3 and H2SO4, where e=([SO3]+[H2SO4])/[ST] and [ST] is the total sulfur atom concentration in the exhaust at the exit of an aircraft gas-turbine combustor, was derived from measurements by comparison with model results. The major results of the presented CIMS experiments and their interpretation with a model simulation are: (i) T...
متن کاملNucleation particles in diesel exhaust: composition inferred from in situ mass spectrometric analysis.
Mass spectrometric measurements of size and composition of diesel exhaust particles have been performed under various conditions: chassis dynamometer tests, field measurements near a German motorway, and individual car chasing. Nucleation particles consisting of volatile sulfate and organic material could be detected both at the chassis dynamometer test facility and during individual car chasin...
متن کاملThermo-mechanical high-cycle fatigue analysis of exhaust manifold of turbocharged engine with two-way coupling FSI
NNowadays, car manufactures in order to increasing torque and power with consider to fuel consumption, have swept to production of turbocharged engines. With consider to exhaust gas-temperature rises in boosted engines, recognition of critical locations of exhaust manifold in the worse condition of engine (full load and maximum speed), to prevent fracture of exhaust manifold is very important. ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Environmental Health Perspectives
دوره 10 شماره
صفحات -
تاریخ انتشار 1975