Microstructural aspects and mechanism of the CX9~to-654 polymorphic transformation in titanium disilicide
نویسنده
چکیده
Microstructural study of the C49-TiSi, to C54-TiSi, polymorphic transformation has been performed to elucidate microstructural evolution and possible mechanism of the phase transformation. It has been shown that the nucleation of the C54-TiSi, is heterogeneous, and preferentially takes place at triple grain junctions or grain boundaries. The interphase interfaces between C49 and C54 disilicides are often ragged with incoherent characteristics. The growth of the 04 phase is found to proceed by advancing the highly mobile incoherent interfaces in all directions toward the heavily faulted C49 phase. No rigorous orientation relationships are found between the two phases. The microstructural features of the transformation bear some massive characteristics.
منابع مشابه
Microstructural Evaluation of Ti-6AL-4V Alloy during Hot Deformation
Among the titanium alloys, Ti-6Al-4V is the most widely used. In the present work, the uniaxial hot compressive behavior of Ti-6Al-4V has been investigated under constant strain rates. A series of dilatometery experiments were carried out to determine the transformation temperatures at different cooling rates. Specimens were homogenized at 1050 °C for 10 minutes followed by fast cooling to dif...
متن کاملMicrostructural Evaluation of Ti-6AL-4V Alloy during Hot Deformation
Among the titanium alloys, Ti-6Al-4V is the most widely used. In the present work, the uniaxial hot compressive behavior of Ti-6Al-4V has been investigated under constant strain rates. A series of dilatometery experiments were carried out to determine the transformation temperatures at different cooling rates. Specimens were homogenized at 1050 °C for 10 minutes followed by fast cooling to dif...
متن کاملFlow Behavior of SP-700 Titanium Alloy During Hot Tensile Deformation in α+β and β Phase Regions
In this paper, in order to study the flow behavior and elongation of as-cast ingots of SP-700 titanium alloy, hot tensile test was done in α/β dual phase and β single phase regions using strain rate of 0.1 s-1. Results showed that the hot tensile behavior of SP-700 in the α/β dual phase region (700-900 ºC) was different from the β single phase one (950-1100 ºC) due to the nature of alpha and be...
متن کاملNondestructive detection of titanium disilicide phase transformation by picosecond ultrasonics
We demonstrate that picosecond ultrasonics is a sensitive nondestructive probe of the formation of TiSi, from the reaction of titanium films on silicon annealed at temperatures of 300-800 “C. From the measured change in optical reflectivity, the responses due to electronic excitation, acoustic echoes, and thermal coupling to the underlying Si are resolved. The results show significant differenc...
متن کاملFracture Mechanism of CoCrMo Porous Nano-composite Prepared by Powder Metallurgy Route
The main aim of this research was to find the mechanism for the failure of the CoCrMo porous nano-composite by characterizing microstructural changes and fractured surface after compression test. For this purpose, porous nano-composites were prepared with the addition of bioactive glass nano-powder to Co-base alloy with 22.5% porosity by the combination of space-holder and powder metallurgy tec...
متن کامل