Anisotropic Conductive Film for Flip-chip Interconnection of a High I/o Silicon Based Finger Print Sensor
نویسندگان
چکیده
Anisotropic conductive film (ACF) has been used for flip chip interconnection of a silicon based MEMS finger print sensor to a signal processing ASIC. The assembled sensor device was subjected to a short term high temperature profile with peak temperature 260 C simulating subsequent reflow soldering of the device, and to thermal shock cycling from -40 to +85 C. The reliability of interconnects during ageing was investigated by monitoring changes in electrical resistance of single interconnects and interconnect daisy chains. The electrical resistance increased after exposure to the high temperature soldering profile, but no failures were observed even after 10 repetitions. Thermal shock cycling showed an increase in electrical resistance and no failures. A relatively large resistance increase was found for some interconnection points.
منابع مشابه
A Roadmap to Low Cost Flip Chip Technology and Chip Size Packaging using Electroless Nickel Gold Bumping
Flip Chip (FC) Technology is gaining an increased level of importance for a variety of applications based on Flip Chip on Board or Flip Chip in Package. The first driving force for the introduction of this Technology was the need to achieve increased speed and performance along with higher I/O count. A breakthrough, however, will be the use of flip chip due to cost reduction. For this aim it is...
متن کاملFlip chip microassembly of a silicon triaxial force sensor on flexible substrates
Miniaturization of microelectromechanical systems (MEMS) based devices can be achieved by flip chip assembly directly onto a flexible circuit substrate. The main goal of this work was the selection of a suitable bonding material and process to enable scaling down of MEMS sensorized devices for biomedical applications. Finally, the heat bondable anisotropic conductive film 5552R (3M) allowed mec...
متن کاملContact Resistance of Anisotropic Conductive Adhesive Film Based Flip-chip on Glass Packages
In a flip-chip-on-glass (FCOG) assembly, anisotropic conductive film (ACF) is used as the adhesive to bind the desired interconnection between the flip chip and glass substrate. However, it remains a challenge to develop the ACF bonded flip chip packages with low contact resistance. Considerable research has been conducted recently to investigate the effect of different parameters on the contac...
متن کاملThermal Cycling Reliability and Delamination of Anisotropic Conductive Adhesives Flip Chip on Organic Substrates With Emphasis on the Thermal Deformation
One of the most important issues whether anisotropic conductive film (ACF) interconnection technology is suitable to be used for flip chip on organic board applications is thermal cycling reliability. In this study, thermally induced deformations and warpages of ACF flip chip assemblies as a function of distance from neutral point (DNP) and ACF materials properties were investigated using in si...
متن کاملProcess Modeling and Thermal / Mechanical Behavior of ACA / ACF Type Flip - Chip Packages
Development of flip-chip-on-glass (FCOG) assembly technology using anisotropic conductive adhesive/film (ACA/ACF) is currently underway to achieve fine pitch interconnections between driver IC and flat panel display. Conductive adhesives are characterized by fine-pitch capability and more environment compatibility. Anisotropic conductive adhesive/film (ACA/ACF) is composed of an adhesive resin ...
متن کامل