Characterization of nitrate particulate dry deposition by vacuum-deposited thin film reaction method

نویسندگان

  • Hsi-Hsien Yang
  • Shih-Kai Cheng
چکیده

Air samples were collected at a highway intersection, coastal location and suburban area in Taichung, Taiwan for the characterization of nitrate containing particulates (NCPs) in dry deposition from October 2002 to February 2003. Sampling was accomplished with a surrogate surface technique in non-raining days. Collecting tapes were precoated with nitron (C20H16N4) in a vacuum evaporator controlled below 10 -6 mm Hg. Immediately after collection, samples were placed in a desiccator with a relative humidity of 85% for 2 hours to form distinctive products of NCPs. These products were then examined with a scanning electron microscopy. It was found that the average number frequencies of NCPs in total particulate were 41.9%, 35.7%, and 36.8% at the highway intersection, coastal and suburban areas, respectively. Most collected particulates were non-nitrate containing at these sampling sites. The average volume shape factor value of NCPs at the highway intersection was higher than those at the other sampling sites, suggesting that NCPs at the highway intersections were more irregular in shape. Average NCP dry deposition fluxes were 3.9, 2.2, 2.1 μg m -2 s -1 and non-nitrate containing particulate (NNCP) dry deposition fluxes were 5.4, 3.9, 3.2 μg m -2 s -1 at the highway intersection, coastal and suburban areas. NCPs less than 10 m in size contributed 3.4%, 9.6% and 6.4% by weight to the total dry deposition at the highway intersection, coastal, and suburban areas, respectively, showing that over 90% of dry deposition was particulates larger than 10 m in diameter. The number median diameters (NMDs) of NCP were 0.47, 0.39 and 0.57 μm and mass median diameters (MMDs) of NCP were 24.2, 26.3, 24.6 μm at the highway intersection, coastal and suburban sites, respectively. The coastal area had the lowest NMD and highest MMD. The average values of dynamic shape factor (FD) were *Corresponding author. Tel: 886-4-23323000 ext. 4451; Fax: 886-4-23742365; E-mail: [email protected]

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Study of Iridium (Ir) Thin Films Deposited on to SiO2 Substrates

Very smooth thin films of iridium have been deposited on super polished fused silica (SiO2) substrates using dc magnetron sputtering in argon plasma. The influence of deposition process parameters on film micro roughness has been investigated. In addition, film optical constants have been determined using variable angle spectroscopic ellipsometery, over the spectra range from vacuum ultraviolet...

متن کامل

Structural Properties of Post Annealed ITO Thin Films at Different Temperatures

Indium tin oxide (ITO) thin films were deposited on glass substrates by RF sputtering using an ITO ceramic target (In2O3-SnO2, 90-10 wt. %). After deposition, samples were annealed at different temperatures in vacuum furnace. The post vacuum annealing effects on the structural, optical and electrical properties of ITO films were investigated. Polycrystalline...

متن کامل

Tailoring the Energy Band Gap of Transition Metal Doped TiO2 Thin Film

Water splitting for hydrogen production under sunlight using TiO2 as photo catalyst provides a better route for solar energy and attracts the attention of many researchers. The photo catalytic activity of TiO2 under sunlight irradiation depends on the band gap energy. The transition metal doped TiO2 shows an edge over TiO2 in optical absorbance and photo catalytic activity. Thin film of Cr dope...

متن کامل

ELECTRICAL CHARACTERIZATION OF ALUMINUM (Al) THIN FILMS MEASURED BY USING FOUR- POINT PROBE METHOD

This paper reports the results of electrical characterization of aluminum thin films. Uniform Al thin films were deposited by physical vapor deposition (PVD) technique on glass substrates. The electrical resistivity of the films as a function of film thickness was studied. These parameters have been measured by four-point probe method. The electrical resistivity was obtained by the measurement ...

متن کامل

Growth, Characterization of Cu Nanoparticles Thin Film by Nd: YAG Laser Pulses Deposition

We report the growth and characterization of Cu nanoparticles thin film of on glass substrate by pulse laser deposition method. The Cu thin film prepared with different energy 50, 60, 70, and 80 mJ. The energy effect on the morphological, structural and optical properties were studied by AFM, XRD and UV-Visible spectrophotometer. Surface topography studied by atomic force microscopy revealed na...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2010