Stresa, Italy, 25-27 April 2007 NANOTRANSFER METHOD OF PZT FILM ONTO THE POLYMER SUBSTRATE
نویسندگان
چکیده
High dielectric capacitor, that has around 1000 in dielectric constant, can be successfully formed by nanotransfer on non-heat-resisting substrates. PZT film could be released from the Si substrate and bonded onto the polymer one. The releasing characteristics have the relationships with the thickness of Pt layer. The formed PZT has perovskite structure and clear columnar texture.
منابع مشابه
Stresa, Italy, 25-27 April 2007 PROFILE CONTROL OF A BOROSILICATE-GLASS GROOVE FORMED BY DEEP REACTIVE ION ETCHING
Deep reactive ion etching (DRIE) of borosilicate glass and profile control of an etched groove are reported. DRIE was carried out using an anodically bonded silicon wafer as an etching mask. We controlled the groove profile, namely improving its sidewall angle, by removing excessively thick polymer film produced by carbonfluoride etching gases during DRIE. Two fabrication processes were experim...
متن کاملStresa, Italy, 25-27 April 2007 LIQUID DENSITY SENSING USING RESONANT FLEXURAL PLATE WAVE DEVICE WITH SOL-GEL PZT THIN FILMS
This paper presents the design, fabrication and preliminary experimental results of a flexure plate wave (FPW) resonator using sol-gel derived lead zirconate titanates (PZT) thin films. The resonator adopts a two-port structure with reflecting grates on the composite membrane of PZT and SiNx. The design of the reflecting grating is derived from a SAW resonator model using COM theory to produce ...
متن کاملStresa, Italy, 25-27 April 2007 IDENTIFICATION OF TEST STRUCTURES FOR REDUCED ORDER MODELING OF THE SQUEEZE FILM DAMPING IN MEMS
In this study the dynamic behaviour of perforated microplates oscillating under the effect of squeeze film damping is analyzed. A numerical approach is adopted to predict the effects of damping and stiffness transferred from the surrounding ambient air to oscillating structures; the effect of hole’s cross section and plate’s extension is observed. Results obtained by F.E.M. models are compared ...
متن کاملStresa, Italy, 25-27 April 2007 NOISE AND THERMAL STABILITY OF VIBRATING MICRO-GYROMETERS PREAMPLIFIERS
The preamplifier is a critical component of gyrometer’s electronics. Indeed the resolution of the sensor is limited by its signal to noise ratio, and the gyrometer’s thermal stability is limited by its gain drift. In this paper, five different kinds of preamplifiers are presented and compared. Finally, the design of an integrated preamplifier is shown in order to increase the gain stability whi...
متن کاملStresa, Italy, 25-27 April 2007 ARCHITECTURE FOR INTEGRATED MEMS RESONATORS QUALITY FACTOR MEASUREMENT
In this paper, an architecture designed for electrical measurement of the quality factor of MEMS resonators is proposed. An estimation of the measurement performance is made using PSPICE simulations taking into account the component's non-idealities. An error on the measured Q value of only several percent is achievable, at a small integration cost, for sufficiently high quality factor values (...
متن کامل