Synthesis and Characterizations of Novel Ca-Mg-Ti-Fe-Oxides Based Ceramic Nanocrystals and Flexible Film of Polydimethylsiloxane Composite with Improved Mechanical and Dielectric Properties for Sensors

نویسندگان

  • Ashish Tripathy
  • Sumit Pramanik
  • Ayan Manna
  • Nabila Farhana Azrin Shah
  • Hanie Nadia Shasmin
  • Zamri Radzi
  • Noor Azuan Abu Osman
چکیده

Armalcolite, a rare ceramic mineral and normally found in the lunar earth, was synthesized by solid-state step-sintering. The in situ phase-changed novel ceramic nanocrystals of Ca-Mg-Ti-Fe based oxide (CMTFOx), their chemical reactions and bonding with polydimethylsiloxane (PDMS) were determined by X-ray diffraction, infrared spectroscopy, and microscopy. Water absorption of all the CMTFOx was high. The lower dielectric loss tangent value (0.155 at 1 MHz) was obtained for the ceramic sintered at 1050 °C (S1050) and it became lowest for the S1050/PDMS nanocomposite (0.002 at 1 MHz) film, which was made by spin coating at 3000 rpm. The excellent flexibility (static modulus ≈ 0.27 MPa and elongation > 90%), viscoelastic property (tanδ = E″/E': 0.225) and glass transition temperature (Tg: -58.5 °C) were obtained for S1050/PDMS film. Parallel-plate capacitive and flexible resistive humidity sensors have been developed successfully. The best sensing performance of the present S1050 (3000%) and its flexible S1050/PDMS composite film (306%) based humidity sensors was found to be at 100 Hz, better than conventional materials.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

COMPARISON OF MECHANICAL AND ELECTRICAL PROPERTIES OF PIEZOELECTRIC COMPOSITES PZT/ZnO AND PZT/Al FABRICATED BY POWDER METALLURGY

Lead zirconate titanate (PZT) as a piezoelectric ceramic has been used widely in the fields of electronics, biomedical engineering, mechatronics and thermoelectric. Although, the electrical properties of PZT ceramics is a major considerable, but the mechanical properties such as fracture strength and toughness should be improved for many applications. In this study, lead monoxide, zirconium ...

متن کامل

Design and Development for Capacitive Humidity Sensor Applications of Lead-Free Ca,Mg,Fe,Ti-Oxides-Based Electro-Ceramics with Improved Sensing Properties via Physisorption

Despite the many attractive potential uses of ceramic materials as humidity sensors, some unavoidable drawbacks, including toxicity, poor biocompatibility, long response and recovery times, low sensitivity and high hysteresis have stymied the use of these materials in advanced applications. Therefore, in present investigation, we developed a capacitive humidity sensor using lead-free Ca,Mg,Fe,T...

متن کامل

Synthesis and enhanced mechanical properties of nano Zinc Oxide in Polyvinyl alcohol and Polyvinyl pyrollidone composite film

Zinc oxide nanoparticles have been synthesized by chemical reaction method.  Polyvinyl alcohol (PVA) composite film filled with nanometric, monodispersed zinc oxide nano particles prepared by PVA solution and nanozinc oxide. Polymer blend with ZnO nanoparticle composite film has prepared by casting technique.  The property of nano composites depends greatly on the chemistry of polymer matrices....

متن کامل

Synthesis and enhanced mechanical properties of nano Zinc Oxide in Polyvinyl alcohol and Polyvinyl pyrollidone composite film

Zinc oxide nanoparticles have been synthesized by chemical reaction method.  Polyvinyl alcohol (PVA) composite film filled with nanometric, monodispersed zinc oxide nano particles prepared by PVA solution and nanozinc oxide. Polymer blend with ZnO nanoparticle composite film has prepared by casting technique.  The property of nano composites depends greatly on the chemistry of polymer matrices....

متن کامل

Synthesis of MgTiO3 Powder Via Co-Precipitation Method and Investigation of Sintering Behavior

A co-precipitation method was used for synthesis of pure MgTiO3 ceramic powder with Mg(NO3)2.6H2O, TiCl4 or C12H28O4Ti and NaOH as raw materials. In this method, solutions of 1 M, Mg (NO3)2 6H2O and 2 M, NaOH were prepared. A stoichiometric amount of Ti precursors from TiCl4 or C12H28O4Ti was weighted. Solutions of Mg (NO3)2. 6H2O and Ti precursor were added dropwise to NaOH solution unde...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:
  • Sensors

دوره 16 3  شماره 

صفحات  -

تاریخ انتشار 2016