A Synchronous Positioning Control Method at Pressure Control between Multi-AC Servomotors Driven in Injection Molding Machine
نویسنده
چکیده
In coping with the trend toward the much higher powered electric-motor driven injection molding machine, multi-AC servomotors control system has become necessary in order to control the molding machine mechanism. Thus, it is inevitable to use a synchronous positioning control technique not to cause the excessive mechanical stress in the machine body. It is possible to realize the synchronous positioning control in the injection velocity control by using position feedback signals from motor pulse-generators. However in the injection pressure control it is much difficult to realize the synchronous positioning control because the pressure-detector signal have to be used in place of the position feedback signals. This paper clarifies the synchronous positioning control method during the injection pressure control by using both the pressure-detector signal and position feedback signals. The experimental results by using a simulator apparatus showed that the synchronous positioning control error was less than ±4μm in the pressure control. Key-Words: Synchronous Positioning Control, Multi-AC Servomotors, Pressure Control, Velocity Control, Injection Molding Machine, Simulator Apparatus
منابع مشابه
Investigation of Two Vector Control Based Methods for Static Synchronous Series Compensator
In this paper, two vector control systems for investigating the performance of Static Synchronous Series Compensators (SSSC) in steady state conditions are presented that are based on famous d-q axis theory. The workability of proposed method to simplify the SSSC mathematical expressions is shown. The performance of SSSC with two different vector controllers, first based on d-q line current...
متن کاملAdaptive Voltage-based Control of Direct-drive Robots Driven by Permanent Magnet Synchronous Motors
Tracking control of the direct-drive robot manipulators in high-speed is a challenging problem. The Coriolis and centrifugal torques become dominant in the high-speed motion control. The dynamical model of the robotic system including the robot manipulator and actuators is highly nonlinear, heavily coupled, uncertain and computationally extensive in non-companion form. In order to overcome thes...
متن کاملOptimization of the injection molding process of Derlin 500 composite using ANOVA and grey relational analysis
Warpage and shrinkage control are important factors in proving the quality of thin-wall parts in injection modeling process. In the present paper, grey relational analysis was used in order to optimize these two parameters in manufacturing plastic bush of articulated garden tractor. The material used in the plastic bush is Derlin 500. The input parameters in the process were selected according ...
متن کاملSpeed Control of A Three Phase Current Forced Synchronous Machine Drive Based on A Simple Method
In this paper, a new method is proposed for the speed control of a three-phase current forced synchronous machine drive. This metohd is based on the use of an approximate constant commutation safety margin angle in the output thyristor bridge of the drive system as well as on the compenastion of stator magnetization reaction. The commutation process in the output converter of the machine driv...
متن کاملSpeed Control of A Three Phase Current Forced Synchronous Machine Drive Based on A Simple Method
In this paper, a new method is proposed for the speed control of a three-phase current forced synchronous machine drive. This metohd is based on the use of an approximate constant commutation safety margin angle in the output thyristor bridge of the drive system as well as on the compenastion of stator magnetization reaction. The commutation process in the output converter of the machine driv...
متن کامل