From ribbons to nanodot arrays: nanopattern design through reductive annealing.
نویسندگان
چکیده
A new approach to the generation of nanoparticle arrays in periodic as well as non-periodic fashions has been discovered based on reduction of oxidized nanoscroll/nanoribbon precursors in the transmission electron microscope (carbothermal reduction) or by hydrogen annealing. Arrays consisting of nickel arsenide nanoparticles of size 3-4 nm have been generated.
منابع مشابه
Fabrication of Highly Ordered Polymeric Nanodot and Nanowire Arrays Templated by Supramolecular Assembly Block Copolymer Nanoporous Thin Films
Realizing the vast technological potential of patternable block copolymers requires both the precise controlling of the orientation and long-range ordering, which is still a challenging topic so far. Recently, we have demonstrated that ordered nanoporous thin film can be fabricated from a simple supramolecular assembly approach. Here we will extend this approach and provide a general route to f...
متن کاملOne-Step Mask Etching Strategy Toward Ordered Ferroelectric Pb(Zr0.52Ti0.48)O3 Nanodot Arrays
In this report, ordered lead zirconate titanate Pb(Zr0.52Ti0.48)O3 (PZT) nanodot arrays were fabricated by an original one-step mask etching route. The one-step mask etching strategy is based on the patterned nanostructure of barrier layer (BL) at the bottom of anodic aluminum oxide (AAO), by a direct transfer of the nanopattern from BL to the pre-deposited PZT film, without introduction of any...
متن کاملFerromagnetic Co-C nanodot arrays produced by direct interferometric laser annealing
Magnetic properties of Co-C nanodot arrays produced by direct interferometric laser annealing are investigated by magnetic force microscopy (MFM) and magnetization measurements. The dots are formed by locally annealing sputtered amorphous Co-C films in regions where the laser intensity is highest. As-sputtered Co-C films do not exhibit ferromagnetic order at room temperature, but MFM shows that...
متن کاملIntroducing and investigating structural and magnetic properties of ribbons Co68.5-xFe4WxSi16.5B11 (x = 0.8, 2) in amorphous and crystalline states
In this study, for the first time, cobalt base ribbons were made by adding two different amounts of tungsten with Co67.7Fe4W0.8Si16.5B11 and Co66.5Fe4W2 Si16.5B11 compounds by melt spinning in the water. The pattern of X-ray diffraction taken from these ribbons shows that these magnetic ribbons are amorphous. By using thermal analysis curves, taken from the ribbons, crystallization temperature...
متن کاملCurling graphene ribbons through thermal annealing
A simple process is developed to curl graphene membranes through thermal annealing. The resulting curled graphene ribbons displayed enhanced photocurrent response compared to flat graphene ribbons. The annealing temperature, the thickness of the graphene, and the type of polymethyl methacrylate used were the three key factors that influenced the morphology of graphene during thermal annealing. ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Chemical communications
دوره 10 شماره
صفحات -
تاریخ انتشار 2006