Sinusoidal Oscillator – a New Configuration Based on Current Conveyor
نویسندگان
چکیده
A new sinusoidal oscillator configuration using two second generation current conveyors (CCIIs) is introduced which requires only two grounded capacitors and two resistors. The proposed structure enjoys independent frequency control through grounded resistor. The circuit is extended to electronic tunability regime by replacing CCIIs with second generation current controlled conveyors (CCCIIs). The frequency of oscillation of the later structure is electronically controllable by bias current of CCCIIs. The simulation results are illustrated to verify theory.
منابع مشابه
Resistor Controlled Voltage-Mode Eight-Phase Sinusoidal Oscillator Using MOCCIs
A simple scheme is given for the realization of a voltage mode three-output sinusoidal oscillator (VMTOSO). Using this scheme a negative type second generation current conveyor, [CCII(-)]-based VMTOSO is realized. The [CCII(-)]-based VMTOSO is then transformed into a multioutput current conveyor [MOCCII]-based voltage mode eight-phase sinusoidal oscillator (VMEPSO) by replacing all the CCII(-) ...
متن کاملA New Differential Difference Current Conveyor Based Variable Frequency Oscillator Adjustable with a Grounded Resistor
A current mode variable frequency sinusoidal oscillator employing single differential difference current conveyor is proposed. The circuit uses two capacitors and three resistors which are minimum in number. The frequency of oscillation can be adjusted by a grounded resistor without disturbing the oscillation condition. The presented topology was synthesized using an innovative genetic algorith...
متن کاملImplementation of Non-Sinusoidal Oscillator using Current Conveyor
---------------------------------------------------------------------***--------------------------------------------------------------------Abstract—A non-Sinusoidal oscillator based on integrating the diode-switched currents and Regenerative Comparator is presented. The Implementation is derived from a known circuit with operational amplifiers where these are replaced by current conveyors. The...
متن کاملExplicit-Current-Output Quadrature Oscillator Using Second-Generation Current Conveyor Transconductance Amplifier
This paper presents a novel quadrature sinusoidal oscillator using second-generation current conveyor transconductance amplifier as an active building block. The proposed circuit employs only a single second-generation current conveyor transconductance amplifier, four passive components. The proposed circuit offers the advantages of independent control of the condition of oscillation and freque...
متن کاملElectronically Tuned Current-mode Quadrature Oscillator with Independently Controllable FO and CO
The realization of current-mode quadrature oscillators using current controlled current conveyor transconductance amplifiers (CCCCTAs) and grounded capacitors is presented. The proposed oscillators can provide 2 sinusoidal output currents with 90o phase difference. It is enabled non-interactive dual-current control for both the condition of oscillation and the frequency of oscillation. High out...
متن کامل