Study of Currents and Temperature of Induced Spur Gear using 2d Simulation
نویسندگان
چکیده
This paper presents the study of induced currents and temperature distribution in gear heated by induction process using 2D finite element (FE) model. The model is developed by coupling Maxwell and heat transfer equations into a multi-physics model. The obtained results allow comparing the medium frequency (MF) and high frequency (HF) cases and the effect of machine parameters on the evolution of induced currents and temperature during heating. The sensitivity study of the temperature profile is conducted and the case hardness is predicted using the final temperature profile. These results are validated using tests and give a good understanding of phenomena during heating process. Keywords—2D model, induction heating, spur gear, induced currents, experimental validation
منابع مشابه
A Study of Precision Forging of Steel Spur Gears: Upper Bound Model and Experiments
Precision forging process is widely used for the production of spur gears due to its advantages such as improved strength and surface finish, little waste of materials and reduction in the machining time of the gear. An important aspect of precision forging process is the load required to perform the process successfully and design the forging tools. In this research, a new kinematically admiss...
متن کاملA Comparative Study of Tooth Wear, Mechanical Power Losses and Efficiency in Normal and High Contact Ratio Asymmetric Spur Gears
The surface tooth wear which occurs at the gear contact region due to inadequate contact strength of the tooth is one of the predominant modes of gear failures. Currently, higher contact ratio spur gears are increasingly used in power transmission applications such as aircraft, wind turbine, automobiles and compact tracked vehicles due to their high load carrying capacity. In this work, the di...
متن کاملNumerical and Experimental Investigation of Cold orBital Forging of a 16MnCr5 Alloy Spur Bevel Gear
The purpose of this research is to analyze the forging of bevel gears based on conventional forging method with material number 1.7131 with finite element method by means of SUPER FORGE software and to compare it with experimental cold orbital forging results.After doing simulation of conventional forging and obtaining press tonnage due to orbital forging method with DEFORM software, orbital fo...
متن کاملInfluence of Addendum Modification Factor on Root Stresses in Normal Contact Ratio Asymmetric Spur Gears
Tooth root crack is considered as one of the crucial causes of failure in the gearing system and it occurs at the tooth root due to an excessive bending stress developed in the root region. The modern power transmission gear drives demand high bending load capacity, increased contact load capacity, low weight, reduced noise and longer life. These subsequent conditions are satisfied by the aid o...
متن کاملThermal Modelling And Simulation Of Automatic Welding System
This paper covers the development, design and simulation of an automatic real time control system applied in mechanical system of recovery of spur gears. using modern techniques of automatic welding. This automatic system permits to recover the initial geometric contour of the wheel by performing automatic welding runs across each tooth, keeping the mechanical properties intact. The thermal mod...
متن کامل