Maximum contaminant levels and environmental injuries.
نویسنده
چکیده
منابع مشابه
Risk assessment of industrial hydrocarbon release and transport in the vadose zone as it travels to groundwater table: A case study
In this paper, a modeling tool for risk assessment analysis of the movement of hydrocarbon contaminants in the vadose zone and mass flux of contamination release into the groundwater table was developed. Also, advection-diffusion-reaction equations in combination with a three-phase equilibrium state between trapped air, soil humidity, and solid particles of unsaturated soil matrix were numerica...
متن کاملManagement of toxic and hazardous contents of oil sludge in Siri Island
Sirri Island is one of the most important islands in Iran where contains massive amounts of crude oil reservoirs and is a crude oil exporting and storage spot. Petroleum sludge wastes produced by the refineries are deposited in outdoor 2-ha open pits. 30 sludge samples from different depot locations were conducted in 3-time intervals and mixed with each other to form one homogenized sample. The...
متن کاملA procedure for setting environmentally safe total maximum daily loads (TMDLs) for selenium.
This article presents a seven-step procedure for developing environmentally safe total maximum daily loads (TMDLs) for selenium. The need for this information stems from recent actions taken by the U.S. Environmental Protection Agency (EPA) that may require TMDLs for selenium and other contaminants that are impairing water bodies. However, there is no technical guidance from EPA or elsewhere th...
متن کاملEvaluation of chemical quality in 17 brands of Iranian bottled drinking waters.
BACKGROUND The purpose of study was to evaluate and compare chemical quality of Iranian bottled drinking water reported on manufacturer's labeling and standards. METHODS This study was a cross-sectional descriptive study and done during July to December 2008. The bottled mineral water collected from shops randomly were analyzed for all parameters address on manufacturer's labeling and the res...
متن کاملPredicting atrazine levels in water utility intake water for MCL compliance.
To protect human health, atrazine concentrations in finished municipal drinking water must not exceed a maximum contaminant level (MCL) of 3 microg/L, as determined by a specific monitoring regime mandated by the United States Environmental Protection Agency. Atrazine levels were monitored along tile-fed drainage ditches draining to a major drinking water source and used to predict MCL exceedan...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- The Journal of contemporary health law and policy
دوره 28 2 شماره
صفحات -
تاریخ انتشار 2012