Fabrication and Testing of Tapered Electro-spray Nozzles
نویسندگان
چکیده
منابع مشابه
Numerical investigation of the effect of swirl and needle lift profile change on the diesel fuel spray behavior
In this study, the effect of creation swirly flow and needle lift profile change on the behavior of the diesel fuel spray considered. To this end, two phase flow inside the diesel injector was simulated using the CFD. Solid works software has been used for geometry creation and AVL-Fire software has been used for meshing and simulating. Firstly, the liquid flow and spray characteristics of the ...
متن کامل3-Dimensional & 2-Dimensional Micro-Orifice Spray Nozzles: Method of Attachment and its effect on Diesel Spray Behavior
The current work discusses our efforts to fabricate 3-D micro-nozzles using a novel, modified MEMS-LIGA process. These nozzles may provide a spray pattern to continue to reduce spray droplet sizes while minimizing interspray drop collisions and optimize the entrainment of air among the array of liquid spray streams. The paper also discusses the efforts made to form a bond between the micro-nozz...
متن کاملRemoval of air ammonia in a spray tower by dilute sulfuric acid solution
Introduction: Workplace air quality is a very important factor in community health and is measured by measuring and evaluating airborne contaminants. One of these airborne pollutants is ammonia gas. Spray towers are important components of air pollution control. The aim of this study was to investigate the effects of using diluted sulfuric acid solution on the efficiency of ammonia removal in a...
متن کاملMeasuring Spray Droplet Size from Agricultural Nozzles Using Laser Diffraction
When making an application of any crop protection material such as an herbicide or pesticide, the applicator uses a variety of skills and information to make an application so that the material reaches the target site (i.e., plant). Information critical in this process is the droplet size that a particular spray nozzle, spray pressure, and spray solution combination generates, as droplet size g...
متن کاملQuasi-Black Mask for Low-Cost LCDs by Patterned Alignment Films Formed by an Electro-Spray Deposition Method
A black mask (BM) is a layer used to improve the display quality by suppressing light leakage. In general, the BM is formed by a photolithography process. In this study, a novel technique for the fabrication of a quasi-black mask (q-BM) is proposed; the q-BM was composed of vertical and hybrid orientation areas, patterned by a separation coating technique using an electro-spray deposition metho...
متن کامل