Ni-Composite Microencapsulated Graphite as the Negative Electrode in Lithium-Ion Batteries II. Electrochemical Impedance and Self-Discharge Studies
نویسندگان
چکیده
Electrochemical impedance and self-discharge studies were carried out to investigate lithium intercalation into bare and Ni-coated KS10 graphite. Values of the charge-transfer resistances, exchange current densities, surface film resistances, and lithium-ion diffusion coefficients as functions of the state of charge (SOC) all favored the 10 wt % Ni composite KS10 graphite over bare KS10 graphite when these materials were used as the negative electrode in a Li-ion cell with mixed organic electrolyte. The charge-transfer resistances were always lower and gave rise to between 26 and 27% larger exchange current densities, which increased from 137 to 614 mA/g as the SOC increased. The surface film resistances for Ni composite KS10 were between 0.02 and 0.05 V g, slightly smaller than those of 0.03 to 0.08 V g for bare KS10, and both surface film resistances decreased with increasing SOC. The lithium-ion diffusion coefficients were always slightly larger, ranging between 1.09 3 1029 and 6.7 3 1029 cm2/s. Results from the self-discharge study also favored the 10 wt % Ni composite KS10, which exhibited less capacity loss over a 10 day period compared to bare KS10. © 2000 The Electrochemical Society. S0013-4651(99)09-057-6. All rights reserved.
منابع مشابه
Ni-Composite Microencapsulated Graphite as the Negative Electrode in Lithium-Ion Batteries I. Initial Irreversible Capacity Study
A novel approach for suppressing the solvated lithium intercalation in graphite was developed by microencapsulating graphite with nanosized Ni-composite particles. The Ni-composite graphite showed great improvement in charge-discharge performance, coulomb efficiency, and cycling behavior when used as the negative electrode in a Li-ion cell with propylene carbonate (PC)-based electrolyte. For ex...
متن کاملImproved Mechanical and Electrochemical Properties of Artificial Graphite Anode Using Water-Based Binders in Lithium-Ion Batteries
In recent years, many studies have focused on the active materials of anodes to improve the performance of LIBs, while limited attention has been given to polymer binders, which act as inactive ingredients. However, polymer binders have amazing influence on the electrochemical performance of anodes. Herein, to investigate the binding performance between MCMB artificial graphite and the copper c...
متن کاملPalladium-microencapsulated graphite as the negative electrode in Li-ion cells
A Pd-encapsulated graphite electrode was used as the negative electrode in Li-ion cells. Through dispersion of ultrafine nanoparticles of palladium on the surface of graphite, the interfacial properties of the carbon surface were modified. The presence of the palladium Ž . dramatically reduces the initial irreversible capacity of the graphite in propylene carbonate PC -based electrolyte. Pallad...
متن کاملInitial Discharge Capacity of Manganese Cobaltite as Anode Material for Lithium Ion Batteries
Nanostructured manganese cobalt oxide spinel (MnCo2O4) are prepared by co-precipitation method and calcined at 650 and 750°C. Morphological studies show that by increasing the calcination temperature from 650 to 750°C, morphology of the particles changes from quasi-plate to polyhedral. The MnCo2O4 calcined at 650°C could deliver an initial discharge capacity of 1438 mAh g-1 under current densit...
متن کاملThe formation mechanism of fluorescent metal complexes at the Li(x)Ni(0.5)Mn(1.5)O(4-δ)/carbonate ester electrolyte interface.
Electrochemical oxidation of carbonate esters at the Li(x)Ni(0.5)Mn(1.5)O(4-δ)/electrolyte interface results in Ni/Mn dissolution and surface film formation, which negatively affect the electrochemical performance of Li-ion batteries. Ex situ X-ray absorption (XRF/XANES), Raman, and fluorescence spectroscopy, along with imaging of Li(x)Ni(0.5)Mn(1.5)O(4-δ) positive and graphite negative electro...
متن کامل