Tape Transport Modeling and Controller Design
نویسندگان
چکیده
A tape transport system consisting of a take-up reel servo, a supply-reel servo, and a capstan servo is proposed. The mathematical model of the system is derived. Two well know controllers – Linear Quadratic Regulator (LQR) and P/PI controller, are designed to regulate the output of the system. An input gain matrix N is calculated and applied to the LQR to eliminate steady-state offset. Simulation is carried out to investigate the step response of the system.
منابع مشابه
Modeling and Control of Lateral Tape Motion for Improved Performance
Introduction The current state of the art for controlling lateral tape motion is a well tuned PID controller that is able to reject all low frequent disturbances. In this paper, we seek to improve this control design by modeling the source of the disturbances in lateral tape motion LTM and designing a controller to reject these specific disturbances instead of all low frequent disturbances. Thi...
متن کاملOn the Design of Nonlinear Discrete-Time Adaptive Controller for damaged Airplane
airplane in presence of asymmetric left-wing damaged. Variations of the aerodynamic parameters, mass and moments of inertia, and the center of gravity due to damage are all considered in the nonlinear mathematical modeling. The proposed discrete-time nonlinear MRAC algorithm applies the recursive least square (RLS) algorithm as a parameter estimator as well as the error between the real ...
متن کاملCooperative Control of Multiple Quadrotors for Transporting a Common Payload
This paper investigates the problem of controlling a team of Quadrotors that cooperatively transport a common payload. The main contribution of this study is to propose a cooperative control algorithm based on a decentralized algorithm. This strategy is comprised of two main steps: the first one is calculating the basic control vectors for each Quadrotor using Moore–Penrose theory aiming at coo...
متن کاملThe Modeling and Control of the Cluster Tool in Semiconductor Fabrication
A single wafer processing IC fabrication with flexible and distributed configuration is getting more important. The cluster tool is such an IC fabrication equipment. It consists of the cassette module, transport module, and process module. In this paper, the model of a cluster tool is constructed using distributed colored timed Petri net (DCTPN). The emulator and controller of the cluster tool ...
متن کاملModeling and Neuro-fuzzy Controller Design of a Wind Turbine in Full-load Region Based on Operational Data
In this paper, dynamic modeling of a Vestas 660 kW wind turbine and its validation are performed based on operational data extracted from Eoun-Ebn-Ali wind farm in Tabriz, Iran. The operational data show that the turbine under study, with a classical PI controller, encounters high fluctuations when controlling the output power at its rated value. The turbine modeling is performed by deriving th...
متن کامل