A 1.8V and 2GHz Inductively Degenerated CMOS Low Noise Amplifier
نویسندگان
چکیده
This paper presents the design and simulation of Low Noise Amplifier (LNA) in a 0.18μm CMOS technology. The LNA function is to amplify extremely low noise amplifier without adding noise and preserving required signal to noise ratio. Cadence design tool Spectre_RF is used to design and simulation based on resistors, inductors, capacitors and transistors. Power constrained methodology is used for the design of Low Noise Amplifier. The amplifier provides a forward gain (S21) of 18.22dB with noise figure (NF) of 2.49dB while drawing 8.1mW power from a 1.8V voltage supply. KeywordsLow Noise Amplifier (LNA), CMOS, noise figure, gain, IIP3
منابع مشابه
A-1.8V Operation Switchable Direct-Conversion Receiver with sub-harmonic mixer
This paper reports on a fully-integrated CMOS switchable directconversion receiver for 2GHz and 5GHz. Switchable low noise amplifier is proposed for suiting for multiband (2GHz, 5GHz). Sub-harmonic mixing is used for down-conversion to minimize the DC-offset due to LO-leakage. The residual DC-offset is cancelled by a digital-to-analog converter at the output of mixer. For quadrature down-conver...
متن کاملAnalysis of Optimization Techniques For Fully Integrated 915MHz CMOS LNA Design
This paper presents an investigation of noise figure optimization techniques for a 915 MHz CMOS Low Noise Amplifier (LNA). The research’s goal is to evaluate the trade off between fully and partially integrated solutions for 915 MHz CMOS LNA. The analysis considers an inductively source-degenerated cascode topology, which is capable of achieving simultaneous noise and input match, with narrow b...
متن کاملNoise Optimization of an Inductively Degenerated CMOS Low Noise Amplifier
This paper presents a technique for substantially reducing the noise of a CMOS low noise amplifier implemented in the inductive source degeneration topology. The effects of the gate induced current noise on the noise performance are taken into account, and the total output noise is strongly reduced by inserting a capacitance of appropriate value in parallel with the amplifying MOS transistor of...
متن کاملA 0.18μm and 2GHz CMOS Differential Low Noise Amplifier
We have proposed a 2 GHz CMOS Differential Low Noise Amplifier (LNA) for wireless receiver system. The LNA is fabricated with the 0.18 μm standard CMOS process. Cadence design tool Spectre_RF is used to design and simulation based on resistors, inductors, capacitors and transistors. Power constrained methodology is used for the design of Differential Low Noise Amplifier. Consuming 9mA current a...
متن کاملA Broadband Low Power CMOS LNA for 3.1–10.6 GHz UWB Receivers
A new approach for designing an ultra wideband (UWB) CMOS low noise amplifier (LNA) is presented. The aim of this design is to achieve a low noise figure, reasonable power gain and low power consumption in 3.1-10.6 GHz. Also, the figure of merit (FOM) is significantly improved at 180nm technology compared to the other state-of-the-art designs. Improved π-network and T-network are used to obt...
متن کامل