Finite Element Analysis Of The Precracked Line Scratch Test
نویسندگان
چکیده
In MEMS packages and silicon devices, the adhesion of interconnects to the substrate is a critical reliability issue. A Precracked Line Scratch Test (PLST) is among one of the available tests to measure the thin line adhesion. In the test, an initial crack is introduced at the interface between the thin line and the substrate. The line is then loaded from the precracked end. The load is recorded continuously while the crack propagates before and after the line buckles. This precracked line scratch test has been applied earlier to tungsten thin lines on silicon wafers [1]. A macroscopic version of the test was also performed to evaluate the analytical model [2]. In the macroscopic tests, polycarbonate lines were bonded to steel substrates with cyanoacrylate. In this paper, finite element analysis is performed for the Precracked Line Scratch Test before line buckling. The energy release rates and phase angles are calculated based on the corresponding load and crack length. The results are then compared to the closed-form solution. Macroscopic experimental model along with the finite element solution has provided a way to derive the interface fracture toughness as a function of the crack length based on the load and crack length history. With the analysis in place, the precracked line scratch test can be used conveniently to study the adhesion of interconnects to passivation layers, MEMS devices and packages on different scales.
منابع مشابه
The Relationship between Constant Friction Factor and Coefficient of Friction in Metal Forming using Finite Element Analysis
Frictional shear stress is usually determined by utilizing the coefficient of friction or the constant friction factor models. The present study deals with finite element analysis of double cup extrusion process to determine the relationship between constant friction factor (m) and coefficient of friction (µ), since the metal flow in this process is very sensitive to frictional conditions. Ther...
متن کاملUsing the Finite Element Analysis Method to Study the 3-point Bending Test for the Characterization of the Adherence
An elastic finite element analysis was conducted to evaluate the stress distribution in the initiation zone of the adhesive rupture during the 3-point bending test. This test is used to measure the adherence between a polyepoxy adhesive and aluminum alloy with different surface treatments. The purpose is to compare, in the high stress concentration areas, the stress fields calculated using fini...
متن کاملA New Restructured Shaded Pole Induction Motor- 3D Finite Element Analysis and Experimental Verification
Shaded pole induction motors, despite the simplicity and low cost, are difficult to analyze particularly in the equivalent circuit methods, due to the asymmetric structure, saturation, harmonics, inaccurate estimation of leakage inductances and skew. Hence, 3D numerical methods could be very useful in the design and optimization stage. This paper presents the 3D transient finite element analysi...
متن کاملEvaluation of Laser-Lok microgrooves on the stress distribution of crestal bone by Finite Element Analysis
متن کامل
بررسی رفتار و طراحی اتصال خمشی با ورق انتهایی هم تراز به روش اجزاء محدود تحت بارگذاری متناوب
The use of steel flush end-plate moment connection is practiced in the construction of the light steel frames around the world particularly in parts of Europe and US. In the past most research was concentrated on studying the behavior of the flush end-plate connection subjected to only monotonic type loadings. The majority of that research carried out such investigation through experimental pro...
متن کامل