Fullerene-Grafted Graphene for Efficient Bulk Heterojunction Polymer Photovoltaic Devices.

نویسندگان

  • Dingshan Yu
  • Kyusoon Park
  • Michael Durstock
  • Liming Dai
چکیده

A simple lithiation reaction was developed to covalently attach monosubstituted C60 onto graphene nanosheets. Detailed spectroscopic (e.g., Fourier transform infrared, Raman) analyses indicated that C60 molecules were covalently attached onto the graphene surface through monosubstitution. Transmission electron microscopic (TEM) observation revealed that these monosubstituted C60 moieties acted as nucleation centers to promote the formation of C60 aggregates of ∼5 nm in diameter on the graphene surface. The resultant C60-grafted graphene nanosheets were used as electron acceptors in poly(3-hexylthiophene)-based bulk heterojunction solar cells to significantly improve the electron transport, and hence the overall device performance, yielding a power conversion efficiency of ∼1.22%.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Morphology of polymer/fullerene bulk heterojunction solar cells

Within the different organic photovoltaic devices the conjugated polymer/fullerene bulk heterojunction approach is one of the foci of today’s research interest. These devices are highly dependent on the solid state nanoscale morphology of the two components (donor/acceptor) in the photoactive layer. The need for finely phase separated polymer–fullerene blends is expressed by the limited exciton...

متن کامل

Stability of graphene-based heterojunction solar cells

Bulk-heterojunction (BHJ) solar cells based on organic small molecules and polymers are the focus of increasing attention by science and commerce. In organic photovoltaic devices, a conjugated polymer layer is used as the donor, while a fullerene-based derivative is used as the acceptor. Poly(3,4ethylenedioxythiophene):poly(styrene sulfonate) (PEDOT:PSS) is one of the most common interfacial ma...

متن کامل

Determining the optimum morphology in high-performance polymer-fullerene organic photovoltaic cells

The morphology of bulk heterojunction organic photovoltaic cells controls many of the performance characteristics of devices. However, measuring this morphology is challenging because of the small length-scales and low contrast between organic materials. Here we use nanoscale photocurrent mapping, ultrafast fluorescence and exciton diffusion to observe the detailed morphology of a high-performa...

متن کامل

A fullerene–single wall carbon nanotube complex for polymer bulk heterojunction photovoltaic cells

A novel immobilized fullerene–single wall carbon nanotube (C60–SWCNT) complex was synthesized via a microwave induced functionalization approach. It has been used as a component of the photoactive layer in a bulk heterojunction photovoltaic cell. As compared to a control device with only C60, the addition of SWCNTs resulted in an improvement of both the short circuit current density JSC and the...

متن کامل

In situ Current Voltage Measurements for Optimization of a Novel Fullerene Acceptor in Bulk Heterojunction Photovoltaics

The evaluation of the power conversion efficiency (PCE) of new materials for organic bulk heterojunction (BHJ) photovoltaics is difficult due to the large number of processing parameters possible. An efficient procedure to determine the optimum conditions for thermal treatment of polymer-based bulk heterojunction photovoltaic devices using in situ currentvoltage measurements is presented. The p...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • The journal of physical chemistry letters

دوره 2 10  شماره 

صفحات  -

تاریخ انتشار 2011