Design of the Spear 3 Magnet Lattice
نویسندگان
چکیده
The SPEAR 3 Upgrade Project seeks to replace the present 160 nm-rad FODO lattice with an 18 nm-rad double bend achromat (DBA) lattice. The new lattice must conform to the layout of the SPEAR racetrack tunnel and service the existing photon beamlines. Working within these constraints, we designed a lattice with 18 achromatic cells and 3 GeV beam energy. This paper reports on design of the main DBA cells, design of the matching cells leading into the 6.5 m racetrack straights, and simulation of the dynamic aperture. The new lattice has gradient dipoles, conventional quadrupoles, and provides horizontal dynamic aperture to ±20 mm with conservative magnetic multipole errors.
منابع مشابه
Quadrupole Shunt Experiments at SPEAR*
As part of a program to align and stabilize the SPEAR storage ring, a switchable shunt resistor was installed on each quadrupole to bypass a small percentage of the magnet current. The impact of a quadrupole shunt is to move the electron beam orbit in proportion to the off-axis beam position at the quadrupole and to shift the betatron tune. Initially, quadrupole shunts in SPEAR were used to pos...
متن کاملSPEAR 3 – A Technology Investment Today for Science Tomorrow
To provide new scientific opportunity and better serve an expanding user community, SSRL will replace the SPEAR storage ring with a 500 mA, 3 GeV machine SPEAR 3. The 4-year, 58 M$ upgrade is funded jointly by the US DOE and the NIH. The main goals are to significantly increase photon beam brightness and stability for the user community. To achieve these goals, the SPEAR 3 project includes a ne...
متن کاملSpear 3 Injection Kicker
The design of the SPEAR 3 injection kicker system is presented. This system will include three kicker magnets and their associated pulsers. The magnet design is based on the DELTA kicker magnets, which present a low RF impedance to the beam, and are relatively straightforward to construct. The pulsers use cascaded IGBT stages that are based on the modulator pulsers developed by a SLAC/LLNL coll...
متن کاملSpear 3 - a Low Emittance Source for Ssrl*
SSRL is planning to upgrade the 3 GeV SPEAR storage ring in FY 2002 to reduce the emittance from 160 nm-rad to 18 nm-rad and to increase the beam current from 100 to 200 mA, and then towards 500 mA as photon beam lines are upgraded. The core of the ’SPEAR 3’ project includes new magnets and power supplies for a DBA lattice, vacuum chamber, and a modedamped RF cavity system. Beam lines will see ...
متن کاملSPEAR III A Brighter Source at SSRL
By replacing the magnets and vacuum chamber for the 3 GeV SPEAR II storage ring, the natural emittance of the machine can be reduced from 130 to 18 nm-rad and the stored current can be raised from 100 to 200 mA with a 50 h lifetime. This configuration increases focused photon flux for insertion device beamlines by an order of magnitude and the photon brightness for future undulators would excee...
متن کامل