Improvement of Energy Efficiency using Porous Fins in Heat Exchangers
نویسندگان
چکیده
The forced convection heat transfer in high porosity metal-foam filled tube heat exchangers are studied in this paper. The Brinkman Darcy momentum model and two energy equations for both solid and fluid phases in porous media are employed .The study shows that using metal-foams can significantly improve the heat transfer in heat exchangers. Keywords—metal foam, Nusselt number, heat exchanger, heat flux
منابع مشابه
Multi-objective optimization of two hybrid power generation systems for optimum selection of SOFC reactants heat exchangers mid-temperatures
Increasing efficiency and decreasing cost are the main purposes in the design of the power generation systems. In this study two hybrid systems: solid oxide fuel cell (SOFC)-gas turbine (GT) and SOFC-GT-steam turbine (ST); are considered. Increasing the SOFC input temperature causes thermodynamics improvement in the hybrid system operation. For this purpose, using two set of SOFC reactants heat...
متن کاملNelder-Mead algorithm optimization and Galerkin’s method thermal performance analysis of circular porous fins with various profiles in fully wet conditions
The main objective of this research is to analyze optimization and the thermal performance of circular porous fins with four different profiles, rectangular, convex, triangular and concave under fully wet conditions. In this research, a linear model was used for the relationship between humidity and temperature. Also, modeling is assumed one-dimensional and the temperature changes only in the d...
متن کاملEnergy Management and Process Improvement of Methanol Production
A heat exchanger network (HEN) for the process of methanol synthesis has been studied by combination of pinch design method and the application of “Twisted Tube” heat exchanger units as a new technology. The HEN is reconstructed based on the full utilization of maximum allowable pressure drops for the process hot and cold streams. An algorithm is developed to generate design procedure for twist...
متن کاملNumerical simulation of a three-layered radiant porous heat exchanger including lattice Boltzmann simulation of fluid flow
This paper deals with the hydrodynamic and thermal analysis of a new type of porous heat exchanger (PHE). This system operates based on energy conversion between gas enthalpy and thermal radiation. The proposed PHE has one high temperature (HT) and two heat recovery (HR1 and HR2) sections. In HT section, the enthalpy of flowing high temperature gas flow that is converted to thermal radiation em...
متن کاملNumerical investigation of heat transfer in a sintered porous fin in a channel flow with the aim of material determination
Extended surfaces are one of the most important approaches to increase the heat transfer rate. According to the Fourier law, the heat transfer increases by increasing the contact surface of body and fluid. In this study, the effect of heat transfer has been investigated on two sets of engineered porous fins, in which the balls with different materials are sintered together. The fluid flow throu...
متن کامل